Walker Edison BKMCPLAT User manual

Revised 02/2020
BKMCPLAT

24 pcs
08 pcs
56 pcs
12 pcs
04 pcs
08 pcs
20
10x40

2x
2x
9
10
Insert wooden dowels (E) into rails (4,,9,10)
J
J
J
J
J
J
J
J
Attach legs (3) to cross bar (4) using bolt (A) and heex key (J)

J
J
J
J
J
Secure part (4) to part (8,9) using bolt (A) and hex key (J)
Connect parts (8,9) to parts (10,11)
Secure parts with screw (O)
O
O
O
O
O
O

JJ
J
J
J
J
J
J
Secure parts (10,11) to parts (8,9) with screw (A) and hex key (J)
J
Attach Feet (12) to frame parts (10,11) using screw (M) and Union Screw (N). Union Screw (N) Should be on the inside
of the bed frame, with screw (M),on the outside of the leg. Tighten by using with hex key(J) on both ends of the screw
at the same time. The use Screw (D) and hex key (J) to secure legs(12).
J
J
M
N
J
M
NJ
J

PPP
P
Q
Q
P20mm
30mm
Secure feet to frame using screw(C).
Attach the metal connector plate (Q) to the 2 corners of the bed with screws (P). Take care to
aligne the plate over the sean of the two parts, as shown in the drawing, before seguring in place.
Start slats assemble
with slat spacer (L)
30mm
B
Secure slat (11) Using Screw (B) and slat spacer (L)
L
L

Step 09