Lightolier LYTECASTER REFLECTOR TRIM User manual

INSTRUCTION SHEET NO.
IS:2026WH
A0203 Page 1 of 1
INSTALLATION OF LYTECASTER®REFLECTOR TRIM IN THE 2000LV/2004ICV SERIES
FRAME-IN KITS WITH ROTO CLIPS
NOTE:
Installation and lamping procedures for the square and round
styles are the same as follows:
1. Frame-In (Fig. A)
See Frame-In Kit Instruction Sheet for installation procedure.
For use with 2000LV/2004ICV series Frame-In Kits only.
2. Rotate Roto Clips (Fig. B)
As shown in Fig. E.
3. Prepare Socket Cup
Remove the Lamp Adjustment Mechanism from the Socket
Cup by bending the the Tabs away (3 places), (see Fig. F & G).
4. Snap-On (Fig. C)
Insert Socket Cup into Housing. Make sure Springs of Socket
Cup snap into Slots of Housing Fig. C.
5. Push-in (Fig. D)
Push Housing Trim straight up until it is tight against ceiling.
6. Lamping (Fig. H and I)
Make sure that power is OFF when lamping or relamping.
Remove Shower Trim from Housing by turning counter-clock-
wise and pulling straight down (Fig. H). Place Lamp into Lamp
Spring until face of Lamp sits firmly onto Glass Lamp Guard (Fig.
I). Attach Socket to Lamp. Insert Shower Trim with Lamp back
into Housing by turning clockwise.
READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE
This fixture is intended for installation in accordance with the National Electrical Code and local
or Federal code specifications. To assure full compliance with local codes and regulations, check with your
local electrical inspector before installation. To prevent electrical shock, turn off electricity at fuse box before
proceeding.
Retain these instructions for maintenance reference.
®
LIGHTOLIER a GENLYTE THOMAS company.
631 Airport Road, Fall River, MA 02720
CAUTION:
•Lamp manufacturers require the Glass Lamp Guard
be in place before energizing lamp (with the
exception of TAL lamps), and that great care must
be taken to insure lamp is fully cooled before
relamping.
NOTES:
•Low voltage fixtures should be dimmed only with
special dimmers intended specifically for that pur-
pose. Use Lightolier Lytemode®, Scenist®,
Crescendo VA®, Neptune VA®, Precision VA®,
Easyset VA®, Sunrise VA®, Radiant VA®, or equiva-
lent products by others; or variable autotransform-
ers or electronic dimmers intended for use with
low voltage fixtures.
Lamp Springs
Lamp
Reflector Lip
FIG. F
FIG. I
FIG. E
FIG. G
FIG. H