Lightolier SADDLE CANOPY KIT Instructions for use

READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE INSTRUCTIONSHEET NO. 7
lis fixture is intended for installation in accordance with the National Electrical Codeand local regulations.
Iassure full compliance with local codes and regulations, check with your local electrical inspector before IS:6063
lstallation. To prevent electrical shock, turn off electricity at fuse box before proceeding.
Retain these instructions for maintenance reference. A1294 Page 1of 1
SADDLE CANOPY KIT
FORUSEWITH 6000OR9100SERIESLIGHTOLIERLIGHTINGTRACKSYSTEMONLY
rhe Saddle Canopy Mounting Kit mounts to any point along the track for feeding power from an outlet box. Extra Dead End Cover is included
:0 replace LIVE END if desired.
CAUTION:TURN OFF POWER AT FUSEBOX BEFOREINSTALLING TRACK.INSTRUCTIONSFOR GROUNDING MUST BE
FOLLOWED.FAILURETO DOSO MAY RESULTIN AHAZARDOUSCONDITION.
1, Attach CROSSBAR to OUTLET BOX as shown in Fig. 1.
2, Mount track to ceiling as shown in Instruction Sheet 6020 or CENTERLINE
OUTLETBOX
9100 bringing lead wires (#1 2ga.) from OUTLET BOX down
(FLUSHWITH CEILING)
either side of track. oEAO END
3. Insert FITTING into TRACK (see Fig. 2) with LOCKING LEVER on COVER
same side of track as BEAD. \
4, Rotate FITTING 90” clockwise until LOCKING LEVER snaps into
place (see Fig. 2).
5. Make wiring connections: black to black, white to white, green TRACK
or bare wire to grounding terminal or ground wire in OUTLET
BOX (see Fig. 3). FITTING I
6. Insert wiring connections into OUTLET BOX (see Fig, 3).
7. Place CANOPY over FITTING, lineup holes in CANOPY with
threaded holes in CROSSBAR, and fasten together with screws CANOPY /“
(included). Make certain that wires do not interfere with proper CANOPY MOUNTING —.!
seating of CANOPY. SCREW
B. LIVE END maybe removed and replaced with DEAD END COVER
(included). FIG. 1
CROSSBAR
,Lo:pR& ~’
LOCKING LEVER
CANOPY
.!
IFIG. 3
1- IC: HTC>L IE1? :::::::iN:=:f..:
FIG.2