Lightolier WIRING OF AGILI-T FIXTURES Instructions for use

525 Education Road, Cornwall K6H 6C7
Tel:[phone] Fax:[phone]
Page 1
Rev.01
READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE
INSTRUCTIONS FOR WIRING OF AGILI-T FIXTURES
This fixture is intended for installation in accordance with the National Code and local regulations.
To assure full compliance with local codes and regulations, check with your local electrical inspector
before installation. To prevent electrical shock, turn off electricity at fuse box before proceeding.
Retain these instructions for maintenance reference.
INSTRUCTION SHEET NO.
SH20300
Page 1 0f
1
NOTE: If supply wires are located within three inches (76.2mm)
of ballast, use wire rated for at least 90 °C
FIXTURE
POWER FEED
END CAP
CANOPY
TEE-BAR
JUNCTION BOX
BIAX CABLE
JUNCTION
BOX
ELECTRICAL
PANEL
(BLACK, RED
WHITE, GREEN)
BUS
(PURPLE, GREY)
COMPUTER
1234
56
1. BLACK (LINE 1)
2. RED (LINE 2)
3. WHITE (NEUTRAL)
4. GREEN (GROUND)
5. PURPLE (DALI CONTROL)
6. GREY (DALI CONTROL)
RECOGNIZED
STRAIN
RELIEF
BY OTHERS
OUTLET
TRANSFORMER
120V TO 12V AC
RECOGNIZED
JUNCTION BOX
BY OTHERS
BIAX CABLE
NETWORK WIRING FOLLOW: