Lightolier LSB-6 User manual

Job Information Type:
Job Name:
Cat. No.:
Lamp(s):
Notes:
"JSQPSU3PBE'BMM3JWFS."tt'BY
We reserve the right to change details of design, materials and finish.
XXXMJHIUPMJFSDPN½1IJMJQT(SPVQt
Lighting Systems LSB-6
1BHFPG -ZUFTQSFBEÜ-4#1JFSDFE-VNJOPVT*OEJSFDU-JHIU51FS'PPU/PNJOBM4FDUJPO
#
Features
1. Housing: Extruded aluminum. Die-cast end cap mechanically attached with
no exposed fasteners or hardware.
2. Lamping:
nominal section. Provided by others.
3. Reflector: Precision die-formed semi-specular aluminum.
4. Shielding: Precision die-formed, pierced 20 gauge CRS. Piercing is four rows
that extend the entire length of the lamps. The pattern is 5/8” (1.59cm) x 1/16”
(0.16cm) slot with a 3/16” (0.48cm) separation between rows.
Electrical
Ballast is <10% THD, .98 ballast factor, pre-heat start. 18 gauge wire. Color-
coded quick connectors allow ease of connection for joiner modules. Power feed
is 18 gauge white SJT. For special circuiting consult factory. Factory installed
ballast disconnect allows the ballast to be disconnected fromand reconnected to
incoming power under load without turning the entire circuit off.
Dimming: 120/277 VAC 1% dimming level, 4 wire feed required.
Emergency Battery Pack: 28 watt: 520 lumens @ 90 minutes, 54 watt: 700
lumens @ 90 minutes, 4 wire feed required.
Mountings
Finish
Powder coated baked white or aluminumfinish. Customcolors available, consult
factory.
Labels
UL, cUL and I.B.E.W.
Ordering Instructions
Individual Fixtures:
1. Order number of MODULES required.
2. Order one POWER FEED END SET per MODULE.
Continuous Rows:
1. Determine run length.
2. Order the appropriate number of MODULES for the complete run.
3. Order one POWER FEED END SET per run.
4. Order one CABLE ASSEMBLY per MODULE minus one per run.
5. For runs that exceed amperage limits, order the appropriate number of
CABLE/CORD ASSEMBLIES.
Options and Accessories
Emergency Circuiting; special circuiting; X, T & L joiner blocks - consult factory.
Complete ordering instructions below.
Cable suspension (not shown) - 4-1/2" (11.43cm) diameter canopy finished white
enamel, 1/16" (0.16cm) diameter stainless steel aircraft cable adjustable up to 36"
(91.44cm). Dual-screw draw-tight connector to create hairline seambetween joiner
modules.
Ordering Information
Family Lamps Voltage Finish
2= 2-Lamp T5 B= Pierced AL = Aluminum
WH = White
LSB 2 B
Length Shielding Ballast
1 = 120 volt
2 = 277 volt
28 = 28W T5
54 = 54W T5
5E = 54W T5 Emergency Pack
2E = 28W T5 Emergency Pack
5D = 54W T5 Dimming
Two T5, 28 or 54 watt (as specified) fluorescent lamps per 4-Foot
4= 4-Foot
8= 8-Foot
Pierce Pattern
3-1/2" (8.89cm)
3/16"
(0.48cm)
5/8"
(1.59cm)
3-1/16"
(7.78cm)
1/16"
(0.16cm)
13 2 4 Fixture Shown Half Scale
8-1/2” (21.59cm)
1-3/4" (4.45cm)

Job Information Type:
"JSQPSU3PBE'BMM3JWFS."tt'BY
We reserve the right to change details of design, materials and finish.
XXXMJHIUPMJFSDPN½1IJMJQT(SPVQt
Lighting Systems LSB-6
1BHFPG -ZUFTQSFBEÜ-4#1JFSDFE-VNJOPVT*OEJSFDU-JHIU51FS'PPU/PNJOBM4FDUJPO
#
Performance
CANDLEPOWER CURVE CANDLEPOWER
ZONE 0 22 45 67 90
DEG.
CANDELAS
180 1118 1118 1118 1118 1118
175 1116 1114 1118 1119 1120
165 1074 1082 1093 1106 1099
155 1000 1014 1044 1081 1093
145 875 911 971 1052 1081
135 713 769 883 1037 1086
125 565 642 858 1084 1098
115 376 513 799 962 1019
105 193 383 612 667 665
95 44 131 83 71 56
90 11 17 12 12 12
85 12 15 15 14 18
75 25 28 31 39 45
65 41 47 57 66 69
55 85 85 99 108 107
45 105 106 114 122 124
35 132 132 136 148 145
25 151 151 151 152 153
15 164 163 164 164 162
5 171 170 172 171 171
0 170 170 170 170 170
REPORT NO: LRL 300-1G
CAT NO: LSB24B28
LAMPS: 2 F28T5
LUMENS: 2900
EFFICIENCY: 83.8%
COEFFICIENTS OF UTILIZATION
% EFFECTIVE CEILING CAVITY
REFLECTANCE
80 70 50
WALL REFLECTANCE
70 50 30 70 50 30 50 30 10
0828282717171515151
1747168656259454342
2686257595450393735
3625549544843353229
4564842494237312725
5524336453732272421
6473832413328242118
7443428383024221816
8403124352722201614
9372822322419181412
10 35 25 19 30 22 17 16 13 11
20% FLOOR CAVITY REFLECTANCE
DISTRIBUTION
Zone Lumens % Lamp % Luminaire
0-90 502 8.7 10.3
90-180 4357 75.1 89.7
0-180 4860 83.8 100.0
Calculations are for 28 watt T5 lamps, for 54 watt T5 lamps multiply by 1.7
Fixture Lengths & Mounting Locations
48"
(121.92cm)
4' 5-1/8"
(134.94cm)
96" (243.84cm)
8' 5-1/8" (256.86cm)
96" (243.84cm)
96" (243.84cm)
96" (243.84cm)
96" (243.84cm) 96" (243.84cm)
96" (243.84cm) 96" (243.84cm) 96" (243.84cm)
48"
(121.92cm)
48"
(121.92cm)
12' 5-1/8" (378.78cm)
16' 5-1/8" (500.70cm)
20' 5-1/8" (622.62cm)
24' 5-1/8" (744.54cm)
4-Foot 8-Foot
12-Foot
16-Foot
20-Foot
24-Foot
Mounting Accessories
Power Feed End Set
Straight Cord: LSBEC36WH (white)
LSBEC36AL (aluminum)
4 Wire Cord*: LSBEC36WHX4 (white)
LSBEC36ALX4 (aluminum)
Cable Assembly
Single Cable: LSBC36
Ceiling Grid Kit
CGK
Includes both Standard 1” (2.54cm
)
Tee Bar Clip & Slot Tee Clip
*Use for dimming, switching, and emergency battery packs.
Cable/Cord Assembly
Single Cable & Cord: LSBCC36
Single Cable & 4 Wire Cord*: LSBCC36X4
4-Foot
Module
8-Foot
Module
Cable/
Assembly
Power Feed
End Set
4-Foot Run 11
8-Foot Run 11
12-Foot Run 11 1 1
16-Foot Run 21 1
20-Foot Run 12 2 1
24-Foot Run 32 1