Lightolier VARIABLEANGLECONNECTOR Instructions for use

.T
READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE INSTRUCTION SHEET NO.
“his fixture is intended for installation in accordance with the National Electrical Code and local regulations,
‘o assure full compliance with local codes and regulations, check with your local electrical inspector before
wtallation. Toprevent electrical shock, turnoff electricity at fuse box before proceeding. IS:9153
Retain these instructions for maintenance reference. 0395 Page 1of 1
VARIABLEANGLECONNECTOR
FOR USEWITH PROFILE,TRACKSYSTEMS ONLY
WARNING:
●TURN OFF POWER AT FUSE BOX BEFORE INSTALLING ELECTRICAL CONNECTOR AND TRACK.
●THE CONNECTOR IS PRE-WIRED AND POLARIZED. THE CONNECTOR ALLOWS CONTINUATION OF POWER BETWEEN
TWO TRACK SECTIONS. THE CONNECTOR MAY BE ADJUSTED TO ANY ANGLE BETWEEN 0° AND 180° (SEE DIAGRAM).
●POWER CANNOT BE FED INTO THE VARIABLE ANGLE CONNECTOR.
A. ADJUST CONNECTOR FOR DESIRED PATTERN. ,:= A,,,
The polarity tabs on the connector must point away from the
,.>=.=...x_<,:-,:
. .... ....3
TRACK BEADS. The TRACK BEADS must be in-line for the
. .. . . .. .
,:.+
connector to insert properly.
B. INSTALLING ELECTRICAL CONNECTOR
1.Point the POLARITY TAB away from the BEAD on the track. ::;,
2. Insert ELECTRICAL CONNECTOR into track. Ensure CONTACT ,~ LOCKINGSCREW
/
BLADES insert into the TRACK CONDUCTOR GAPS. ~TRACK BE
3.Tighten LOCKING SCREWS. \‘,
4. Mount Track per instruction sheet IS:91OO, included with the .___ J_,
track unit. :1:: --:s”-~, 180”
TMENT
9
TRACK CONDUCTOR GAP
,oAR~TAB->~BEAD
—
.—=
‘—CONTACT BLAOE ,
,ffi_:=:-~-
-—–- .
k:? s“~
% - TRACK BEAD
C. OTHER APPLICATIONS FOR VARIABLE CONNECTOR
CEILING TO WALL
--$ WALL INSIDE CDRNER +-
~’
,, WALL INSIDE CORNER
~, WALL OUTSIDECORNER
@FALL RIVER, MASSACHUSETTS, 02720
1.1 C>l+icml 1: 1? MONTREAL, QUEBEC, CANADA
4