Lightolier LTC Series User manual

LTC Series
LOW VOLTAGE TRANSFER CIRCUIT FOR DOWN-LIGHTING
Page 1 of 2
Job Information Type:
Job Name:
Cat. No.:
Notes:
Features
Illumination: The low voltage
transfer circuit is a two channel
device providing switching for
up to 75 W per channel and is
designed to convert existing
low-voltage lighting into
emergency lighting when paired
with a 12 VDC emergency
battery unit.
Housing: Housing and
cover are constructed of
20 gauge galvanized steel.
Three knockouts for conduit
attachment are provided. A
grounding lead is provided
inside the housing.
Operating Temperature
Range:
32°F (0°C) to 122°F (50°C)
Electronics: Load - Reverse
polarity protected with low
battery voltage disconnect
(standard in all Lightolier
emergency battery units).
Special Requirement -
Determine the maximum
wattage draw of the down-light
fixture and be certain that the
12 VDC emergency supply
unit equipment is capable
of sustaining that load for a
minimum of 90 minutes as
required by code.
Electrical Specifications:
Input Power Requirements at
12 VAC - .72 W
Output Power Requirements
at 12 VDC - 2 channel at 75 W
maximum each
Code Compliance
Listed for insulated ceiling
systems (IC Rated). Damp
location listing standard. ETL
listed to UL 924 standards.
Warranty
Three years full warranty.
LTC
2.725"
(6.921 cm)
5.5"
(13.97 cm)
1.29"
(3.277 cm)

LTC Series
LOW VOLTAGE TRANSFER CIRCUIT FOR DOWN-LIGHTING
Page 2 of 2
Philips Lightolier
e: [email protected]
t: [phone]
w: www.lightolier.com
LTC Series August 12, 2011
Specifications are subject to change without notice.
© Koninklijke Philips Electronics N.V., 2011.All rights reserved.
Job Information Type:
Ordering Information
Series
LTC = Low Voltage
Transfer Circuit
LTC
Installation
One Lamp observe
proper
polarity
12 VDC
Emergency
Unit
Equipment
indicates
original
wiring path
Low Voltage
Transfer Module
Xfmr 1
Lighting
Fixture
Xfmr 1
Lamp 1
12 V 75 W MAX
Lamp 1
Xfmr 1 Xfmr 2
LAMP CONN L1 L1 L2 L2
AC1 AC1 AC2 AC2
EMERGENCY
POWER INPUT
L- L+
Two L amp observe
proper
polarity
12 VDC
Emergency
Unit
Equipment
indicates
original
wiring path
Low Voltage
Transfer Module
Xfmr 1
Lighting
Fixture Xfmr 1
Lamp 1
12 V 75 W MAX
Lamp 1
Xfmr 1 Xfmr 2
LAMP CONN L1 L1 L2 L2
AC1 AC1 AC2 AC2
EMERGENCY
POWER INPUT
L- L+
Xfmr 2
Lamp 2
12 V 75 W MAX
Lamp 2
Xfmr 2