Replace hose
Remove the hose
1 Pull out the hose leaving 2 to 3 ft.
(0,6 to 0,9 m) on the spool.
2 Engage the latch pawl.
3 Remove the screw nuts on the inside of
the spool († fig. 10).
4 Remove the hose clamp.
5 Unthread the hose at the connection to
the swivel.
6 Use a wrench on both fittings or the
swivel may be damaged.
7 Remove the hose.
Install hose
1 Route the hose through the guide arm
rollers and opening of the spool.
2 Apply thread tape or sealant to hose
threads.
3 Screw hose fitting into threaded fitting on
swivel.
4 Tighten connection with a wrench on both
fittings.
5 Install the hose clamp († fig. 10).
6 Install hose bumper on working end of
hose.
7 Disengage latch pawl and allow hose
to retract.
Fig. 10 Replace swivel
1 Remove the hose († Replace hose).
2 Remove swivel by unscrewing the
threaded stem from the main shaft
(† fig. 11).
3 Replace swivel by screwing threaded stem
of swivel into main shaft of reel.
4 Replace the hose.
Fig. 11
Service parts
Model Model
Item
Number
Description
Quantity
83753
3/
8
in. x 50 ft.
(0,37 mm x 15,24 m)
83754
1/2 in. x 50 ft
(12,7 mm x 15,24 m)
1 Swivel assembly 1/4 inch NPT 1 279135 279136
15 Hose clamp 1 272167 272168
18 Ratchet and spacer assembly 1 279134 279134
28 Hose assembly 1 278749 278752
29 Bumper assembly 1 278665 278664
32 Latch pawl assembly 1 279133 279133
!Notice
Do not use rigid plumbing.
Use flexible hose connection at input.
Do not exceed recommended torque
of 70 ft.lbf. (94 Nm).
Model 83753 swivel assembly has 1/4
inch NPTF internal threads and Model
83754 swivel assembly has 1/2 inch
NPTF internal threads.
Connecting hose not included.
5
