Radio Frequency Energy, Certifications
Technical Data
Functions Transmitter Receiver
PS2 Mouse Port (Green) 2 x MD-6 female 2 x MD-6 female
PS2 Keyboard Port (Purple) 2 x MD-6 female 2 x MD-6 female
Power Adaptor No DC5V, 2.5A
Weight approx. 41g 39g
Dimension (mm, lxwxh) 50x43x24 50x43x24
Shielded cables must be used with this equipment to maintain
compliance with radio frequency energy emission regulations
and ensure a suitably high level of immunity to
electromagnetic disturbances.
FCC Warning
This equipment has been tested and found to comply with the
limits for a Class B Digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
Reorient or relocate the receiving antenna
Increase the separation between the equipment and receiver
Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected
Consult the dealer or an experienced technician for help
You are cautioned that changes or modifications not expressly
approved by the party responsible for compliance could void your
authority to operate the equipment.
LINDY No. 32385
© LINDY ELECTRONICS LIMITED & LINDY-ELEKTRONIK GMBH - First Edition - DEC 2003
Manuel Utilisateur
Caractéristiques
• Interface PS/2 pour clavier et souris
• Utilisation de câbles PS/2 pour étendre les signaux
clavier et souris jusqu’à 150m.
• Pas d’installation logicielle nécessaire
Installation & Utilisation
Avant d’installer l’Extender, assurez-vous d’avoir éteint tous
les ordinateurs et les périphériques.
Connectez les deux câbles PS/2 aux ports souris et clavier du
PC ou du commutateur KVM aux ports PC IN sur le
Transmetteur
. Pour permettre de connecter correctement le
clavier et la souris, les connexions sont différenciées par des
couleurs.
Connectez deux câbles PS/2 de la longueur appropriée aux
ports EXTENDER sur le
Transmetteur
et le
Recepteur
.
Connectez votre clavier et souris aux ports KB et MS sur le
Récepteur
.
Connectez l’alimentation au
Récepteur
et allumez-le. Allumez
ensuite l’ordinateur et les périphériques.
Si vous souhaitez utiliser l’Extender pour connecter un PC à
un commutateur KVM ou pour connecter deux KVM ensemble,
suivez le diagramme ci-dessous:
