Lindy FireWire 800 User manual

- 1 -
FireWire 800 3Ports PCI Host
1. Introduction
This FireWire800 3Ports PCI Host has IEEE P1394b / FireWire 800
2Ports and 1394a 1Port at PCI card to Transmit and Receive Data at 800/
400/ 200/ 100 Mbits/s. It provides a 32bit 33 MHz and 64bit 33MHz PCI
interface on the host side.
Apple Mac OS X v10.2.4 or newer support Built-in 800Mbps driver for this
card. Mac OS 8.6 – Mac X v10.2.3 just support Built-in 400Mbps driver for
this card.
1.1. Features
1.1.1. PCI Interface
= Compliant with PCI Specification, revision 2.2.
= Integrated PCI DMA engines.
= 32 bit/33MHz and 64 bit/33MHz fully compliant PCI host interface.
1.1.2. IEEE 1394 ( FireWire 800 /400 /200 /100 )
oOn Board Power connector to have Extra power input from system
power supply
oSupports data transfer rate up to 800 Mbps
oFully supports Provisions of IEEE P1394b Revision 1.33+
oFully Supports Provisions of IEEE 1394a-2000 and 1394-1995
Standard
oOne External 1394a-2000 Fully Compliant Cable Port at S400, S200,
S100 speed
oTwo Bilingual (9-pin) Cable Ports at S800 or S400b speed
oSupports Plug and Play
1.2. Package Contents
= FireWire800 PCI card
= Y-type Power Cable
= This Users Manual

- 2 -
2. Installation
1. Power down the computer system.
2. Insert the PCI board into an available 32bit or 64bit PCI slot.
3. Connect Y-type Power cable to PCI board and System Power supply
4. Power up computer.
5. The applicable device driver will be installed automatically
2-64100-01A