Lindy USB 2.0 4+1 Port PCI Card 51084 User manual

USB 2.0
4+1 Port PCI Card
User Manual English
LINDY No. 51084
www.lindy.com
For Home and Office Use
Tested to Comply with FCC Standards

Introduction
Thank you for purchasing this LINDY USB 2.0 PCI Card. This 32-
Bit PCI Card allows you to connect up to 4 USB 2.0 devices to your
computer.
Packing List
USB 2.0 4+1 Port PCI Card
Driver CD
This manual
Features
5 USB 2.0 ports (4 are external and 1 is a shared internal port)
32-Bit PCI
Auto detects connection and speed of devices
Supports High Speed Data Transfer Rates of up to 480 Mbps
Normal and low power operating modes
Plug & Play compatible
Backwards compatible with USB 1.1 devices
System Requirements
PC or Mac with an available 32-Bit PCI slot
CD-ROM Drive
PC: Windows 98SE/ME/2000/XP
Mac: OS 10.x

Hardware Installation
1. Power off your computer
2. Remove the case cover screws and remove the case
3. Locate a spare 32-Bit PCI slot
4. Unscrew the PCI slot blanking plate and retain the screw
5. Carefully insert the PCI card into the slot. Make sure it is
seated correctly
6. Secure the card using the retained screw
7. Replace the case and reinstall the screws
8. Power on your computer and proceed with driver installation
Driver Installation (Windows)
1. Boot up the operating system
2. Insert the Driver CD into your CD-ROM drive and locate the
following path -
\USB\70580\PC Driver
3. Click the Setup.exe file to begin installation. After the files are
copied you will be asked to restart your computer. Select Yes,
I want to restart my computer now

4. After restarting your system, please launch Windows device
manager –
[My Computer]Æ[Properties]Æ[Hardware]Æ[Device Manager]
5. Check for the correct entry (as outlined below) -
Note! If there is a yellow exclamation mark against the NEC PCI to
USB 2.0 Enhanced Host Controller or USB 2.0 Root Hub
Device, please remove this item from the Device Manager by
clicking the Uninstall button, then click Refresh to reinstall this
driver again.

Driver Installation (Mac OS 10.x)
For OS X 10.2 or later:
Use the file USB2EHCI_v2_0.img.bin in the /USB/USB2.0-
NEC/MAC 10.2 directory on the driver CD.
For OS X 10.1.x:
Use the file USB2EHCI_v1075.img.bin in the /USB/USB2.0-
NEC/MAC 10.1.5 directory on the driver CD.
1. Double click the file icon; Stuffit Expander will run
automatically. It will ask you for the destination to extract the
files. Simply select Desktop as your destination and click the
Choose button.

2. The driver will be extracted on to your desktop. It is stored in
disk image format; the image will be mounted automatically
3. Double click on the driver file icon. You will be prompted to
enter your password. If your account does not have
administrative access, you must enter the user name and
password that does.

4. The Welcome to the USB 2.0 EHCI Support v2.0 Installer
will appear. Click the Continue button
5. Select your Mac OS X system drive then click the Continue
button
6. Click the Install button to perform the installation procedure

7. Click the Continue Installation button to confirm
8. Click the Restart button to complete installation
www.lindy.com
2
nd
Edition April 2005