Linksys HGA9N Original operating instructions

Model No.
Model No.
QUICK INSTALLATION
BUSINESS SERIES
High Gain Omni-Directional
Package Contents
• Antenna Body
• Antenna Cable
• Lightning Protector
• Mounting Kit
• Registration Card
•UserGuideonCD
• Quick Installation Guide
IMPORTANT: Before placing and
connecting the High Gain
Omni-Directional Antenna, you
should have determined its
optimum location. If you have
not done this, refer to the User
Guide, “Chapter 2, Planning
Your Wireless Ante n n a
Coverage”.
Quick View
The general outline of a typical
external antenna setup is as follows:
The lightning protector is connected
to the Antenna. The Antenna Cable
is connected to the lightening
protector and then connected to the
Access Point. It is very important to
connect the polarities correctly. The
cable end with the white tape must
be connected to the Access Point.
AMake sure you have all of
the hardware displayed
here (images are not to
scale), including a plastic
bag containing the
mounting hardware.
Connecting the Antenna
Model No. HGA9N
Wireless
Antenna for N Type
Connectors
A
BThe bottom of the Antenna
has a removable black
covering. Remove this and
attach the lightening
protector as illustrated
below by inserting the
male end of the protector
into the Antenna.
CAttach the male cable end
of the cable (the end
without the white tape) to
the lightning protector.
DAttach the male end of the
cable that has the white
tape around it to the
Wireless-G Exterior Access
Point.
Congratulations!
The connection is complete. Proceed
to the next section for bracket
mounting instructions.
1
9dBi Omni-Directional
Antenna
Lightening Protector
Cable
Exterior Access Point
B
C
D

Linksys is a registered trademark or trademark of Cisco Systems, Inc. and/or its affiliates in the U.S. and
certain other countries. Copyright © 2006 Cisco Systems, Inc. All rights reserved.
HGA9N-QI-60828NC SW
For additional information or troubleshooting help, refer to the User Guide on the Setup CD-ROM. You
can also email for further support.
Website
http://www.linksys.com or
http://www.linksys.com/international
2
2
Pole Mounting Bracket Assembly
You can mount the Antenna to a
base (such as a wall) or to a pole.
Before you do this, you will need
to assemble the mounting
bracket. The small page of
mounting hardware should be all
you need for either a base or pole
mounting.
If you are mounting the Antenna
to a base (not included), make
sure the base is secure. Follow the
assembly instructions below to
assemble the mounting bracket.
1Antenna 1 pc
2Sticker 1 pc
3Plastics fixings 4 pcs
4Holder 1 pc
5Washers 4 pcs
6Screws 4 pcs
Base Mounting Bracket Assembly
If you are mounting the Antenna
to a pole, follow the instructions
below to assemble the bracket
and then insert the pole (not
included) into the mounting
bracket assembly.
1Antenna 1 pc
2Hose clamp 2 pcs
3Holder 1 pcs
4Washers 4 pcs
5Screw nuts 4 pcs
Congratulations!
The connection is complete. You can
now begin using the Antenna.
For more detailed information, see
the User Guide contained on the
CD-ROM.