Linn AKUBARIK User manual

Thank you for purchasing the Linn Akubarik loudspeakers. This guide provides
basic unpacking and connecting information to get you started - contact your Linn
Specialist for full installation support.
IMPORTANT:
Please refer to the printed Safety Information booklet for important safety
information and www.linn.co.uk/akubarik for further information on
your Linn Akubarik loudspeakers.
Unpacking
Loudspeakers are packed individually
with a separate package containing
both speaker stands.
Carefully remove products from
packaging and place on a flat surface
- take care when unpacking to avoid
damage to the cabinets.
Do not lay the loudspeakers on their
front face or the amplifier on the rear
as this will damage the loudspeaker.
Please retain all packaging for future
transport of your Akubarik loudspeakers.
•
•
•
•
Installing
1.
2.
Retain the transit plinth and keep with
product packaging.
Position the speaker stand above the
speaker as shown and attach using the 5
bolts removed in step 2.
Take care not to over tighten the bolts.
3.
4.
AKUBARIK
QUICKSTART
IMPORTANT:
The Akubariks are heavy; take great care when moving them. When unpacking,
lifting or moving them, we recommend using two people to avoid personal injury.
Do not lift your Akubarik using the amplifier module, this will cause damage
to your loudspeaker.
Without laying the speaker on its front or rear face, carefully return the
speaker to its upright position.
5.
Adjust the spikes to level the speaker, using a spirit level placed on the stand.7.
Once the speaker is level, fit and tighten the lock nuts with the spanner provided.8.
Screw the spikes into the corners of the stand.
6.
(6) (8)(7)
On a clean, level surface that will not
damage the loudspeaker; carefully stand
the speaker upside-down without laying
it on its front or rear face.
Remove the transit plinth using a
13mm socket spanner.

Connecting
Before making any connections, switch off the rest of the system.1.
Connect the audio input of your Akubarik to the balanced output of
your Linn DSM or pre-amplifier.
Connect your mains cable and switch on the system, always switch
on your loudspeakers last.
2.
3.
Warranty
Your Akubarik loudspeakers come with a 5 year parts and labour warranty as standard
- please visit www.linn.co.uk/warranty if you wish to register your product.
Linn Products Limited
Glasgow Road, Waterfoot, Eaglesham,
Glasgow G76 0EQ, Scotland, UK
•Phone:[phone] •Fax:[phone]
•Helpline:0500 888909 •Email:[email protected]
•Website:www.linn.co.uk
Pack 1671 Copyright© 2013 LinnProductsLimited
Signal sensing:
When an audio input signal is detected, the amplifier is enabled and the blue
LED’s will illuminate.
If the amplifier does not recieve an audio signal for approximately 20 minutes
it will revert to sleep mode.
Protection:
Under fault conditions e.g. over temperature, both blue and red LED’s will illuminate
and the amplifier will shut down in order to protect itself and the drive units.
Once the condition has cleared the amplifier will automatically resume normal operation.
Online Support
Please visit http://docs.linn.co.uk to view the latest information, including advanced
setup instructions, for Linn Akubarik.
Operating
General:
When power is first applied the red LED will illuminate and will remain on
while the amplifier is in sleep mode.