Little Giant LOCK TAB INNER User manual

LOCK TAB INNER ASSEMBLY REPLACEMENT
READ THESE INSTRUCTIONS COMPLETELY BEFORE YOU START. IF YOU DON’T
UNDERSTAND THESE INSTRUCTIONS, PLEASE CALL 800-453-1192 FOR ASSISTANCE
Procedure for replacing the inner assembly on Little Giant Ladder Systems Lock Tab
ladders.
1. Failure to comply with all instructions may result in serious injury.
2. Make sure this kit is compatible with your ladder. If you have any questions concerning
the use of this kit on Little Giant Ladder Systems products, call 800-453-1192 for
assistance.
3. Before installing this kit, identify all kit components. If any components are missing or
damaged, please contact Customer Care. Do not substitute any components.
4. Inspect the ladder before installing this kit. Repair or replace any damaged or missing
ladder parts before using the ladder. Use only Little Giant Ladder Systems repair or
replacement parts. If you are unable to repair it, discard the ladder.
COMPONENTS IN KIT
NOTE: IF ANY OTHER PART OF THE LADDER IS DAMAGED BEFORE OR DURING
THE PROCESS OF INSTALLING AND/OR REPAIRING, DISCARD THE LADDER OR
CONTACT CUSTOMER CARE FOR INSTRUCTIONS.
DO NOT USE A DAMAGED LADDER!
80401 v1 4.14 (1)

80401 v1 4.14 (2)
1. Pull out lock tabs to disengage outer assembly
from inner assembly.
2. Remove the outer assembly.
4. Insert the new inner assembly into existing outer
assembly.
3. Repeat steps 1-2 on opposite side. Then discard old
inner assembly.
5. Re-engage lock tabs to lock the outer assembly
to the inner assembly.
6. Repeat steps 4-5 on opposite side. Once completely
replaced, stand the ladder up and make sure that it is
stable before use.