Living & Co LOH19007W User manual

7 fin Oil Column Heater
1900W
LOH19007W

03 SAFETY INSTRUCTIONS
05 ASSEMBLY INSTRUCTIONS
06 INSTRUCTIONS FOR USE
07 MAINTENANCE
08 WARRANTY
2

3
IMPORTANT: Read these instructions fully before using the heater.
Retain these instructions for future reference.
1.This appliance is not intended for use by persons (including children)
with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or
instruction concerning use of the a ppliance by a person responsible for
their safety.
2.Children should be supervised to ensure that they do not play with the
appliance.
3.The product is for household use only.
4.Connect the appliance to single phase AC supply of the voltage specified
on the rating plate.
5.Warning: In order to avoid overheating, do not cover the heater.
6.Never leave the heater unattended while it is in use. Always turn the
product to the OFF position and unplug it from the electrical outlet when
not in use.
7.Extreme caution is necessary when any heater is used by or near
children, invalids or elderly person and whenever the heater is left
operating and unattended.
8.The heater must not be located immediately below an electrical socket-
outlet.
9.Do not run cord under carpeting and do not cover cord with throw rugs,
runners or the like. Arrange cord away from traffic area and where it will
not be tripped over.
10. Do not operate the heater with a damaged cord or plug, or after the
heater malfunctions, has been dropped, or damaged in any manner.
11. If the supply cord is damaged, it must be replaced by the manufacturer
or its service agent or a similarly qualified person to avoid a hazard.
12. Avoid the use of an extension cord as this may overheat and cause a
risk of fire.
13. Use the heater in a well-ventilated area. Do not insert or allow objects
to enter any ventilation or exhaust opening. To prevent a possible fire, do
not block air intakes or exhaust openings in any manner. Do not use on
soft surfaces, like a bed, where openings may become blocked. Use the
heater on flat, dry surfaces only.

outlet fitted with a residual current device (RCD) with a rated operating
23. NOTE: It is normal when the heaters are turned on for the first time, or
22. The cord shouldn’t be placed near the hot surfaces of the appliance.
18. Be sure that no other appliances are in use on the same electrical
not let bare skin touch hot surfac es. If provided, use handles when
17. This heater is hot when in use. To avoid burns and personal injury, do
or a swimming pool. Never locate the heater where it may fall into
16. Don’t use this heater in the immediate surroundings of a bath, a shower
hot, arcing, or sparking parts inside the heater.
flammable liquids are stored e.g. garages or workshops as there are
materials, surfaces or substances at least 1m from the front of the
bathtub or other water container.
moving the product.
circuit as your product as an overload can occur.
19. This heater is filled with a precise quantity of special oil.
20. Repairs requiring opening of the oil container are only to be made by the
manufacturer or his service agent who should be contacted if there is
an oil leakage.
21. Regulations concerning the disposal of oil when scrapping the
appliance have to be followed.
when they are turned on after having not been used for a long period of
time,that the heaters may emit some smell and fumes, This will disappear when
the heater has been on a short while.
24. Never operate the appliance with wet hands
25. For additional safety, it's recommended that this heater is always used on an
residual current not exceeding 30mA.
14.Do not place this heater near flammable materials, surfaces or
substances, as there may be a risk of fire. Keep the above flammable
product and keep them away from the sides and rear.
15.Do not use the heater in any areas where petrol, paint or other
4

5
ASSEMBLY INSTRUCTIONS
Wheels
(with indicator light)
8
8. Turbo Fan air outlet

6
INSTRUCTIONS FOR USE
(ensure Timer switch is set to "I").

7
SPECIFICATION
220 - 240Vac 50Hz
1900 Watts
CLEANING THE HEATER
Always unplug the heater from the wall socket and allow to cool down before cleaning.
WARNING:
Do not immerse the heater in water.
Do not use any cleaning chemicals such as detergents and abrasives.
Do not allow the interior to get wet as this could create a hazard.
1. Clean the outside of the heater by wiping with a damp cloth and buffing with a dry cloth.
2. To store the heater, wrap the cord around the cable bobbin and store in a cool dry place.
3. In case of malfunction, do not try to repair the heater yourself. This may result in a fire
hazard or electric shock.
Responsible Disposal
At the end of its working life, do not throw this product out with your household
rubbish. Electrical and electronic products contain substances that can have a
detrimental effect on the environment and human
health if disposed of inappropriately. Observe any local regulations regarding
the disposal of electrical consumer goods and dispose of it appropriately for
recycling. Contact your local authorities for advice on recycling facilities
in your area.
Please keep the original packaging carton and materials in a safe place.
It will help to prevent any damage if the product needs to be transported in
the future. In the event it is to be
disposed of, please recycle all packaging
material where possible

8
3
3