
6
3 pin socket - outlet that is well earthed
(grounded).
CLEANING THE HEATER
Always unplug the heater from the wall socket and allow to cool down before cleaning.
WARNING:
Do not immerse the heater in water.
Do not use any cleaning chemicals such as detergents and abrasives.
Do not allow the interior to get wet as this could create a hazard.
1. Clean the outside of the heater by wiping with a damp cloth and buffing with a dry cloth.
2. To store the heater, wrap the cord around the cable bobbin and store in a cool dry place.
3. In case of malfunction, do not try to repair the heater yourself. This may result in a fire
hazard or electric shock.
SPECIFICATION
220 - 240Vac 50Hz
2000-2400 Watts
Ensure wheels are attached and heater is in the upright position.
To switch the heater off, turn the power switch to the off position (“0”) and turn the thermostat knob to the
minimum position (“Low”). When not in use we also recommend removing the mains plug from the
socket-outlet.
Note: The pilot light indicates the on/off status of the thermostat. If the thermostat is positioned in the
“high” setting and the power switch is in the off position (“0”) the pilot light will still illuminate. This does
not indicate that the elements are in operation, heating will only occur when the power switch is in
position “I” “II” or “III".
"High"