6
1. Place the chopper bowl on a clean, level surface.
2. Assemble the stainless chopping blade into the chopper bowl, as shown
in Fig.1.
3. Place ingredients into the chopper bowl.
Note: remove the bone off the meat; cut into small pieces, then place the
meat into a bowl, the max quantity of meat cannot exceed 200g when
blending.
4. Attach the lid onto the chopper bowl, make sure the tube on the inside
wall of bowl aligns with the groove of the lid, turn it in a clockwise direction
until it locks into position. (Fig.2) To detach the lid, turn in an anti-clockwise
direction.
5. Insert the motor unit into the hole of the chopper lid, and turn in clockwise
direction to lock. (Fig.3)
6. Plug in the appliance to a power outlet. Press and hold the on/off button at
low speed to start operating. Select the desired speed setting by dialing
the speed control dial, there are five settings: 1, 2, 3, 4, 5 (from low speed
to high speed).
7. Alternatively you can start operating by press and holding the high speed
button (turbo button), the appliance will operate at the highest speed.
Note:The speed will not change even if you change the speed control dial.
8. Stop the appliance by releasing the on/off button or high speed
(Turbo) button of the main motor unit.
9. After finishing chopping, unplug the power outlet.
10. Open the chopper lid by turning it anti-clockwise and remove the chopped
food.
Caution:
-To reduce the risk of injury, never place the cutting blade on the base
without first connecting the bowl properly in place.
-Be sure the chopper lid is securely locked in place before operating the
appliance.
-Never remove the chopper lid with the motor unit in place.
Chopping
CAUTION: Max operating duration/time cannot exceed 60 sec and only
wait until the unit is cooled to room temperature before performing
further operation.
