
OPERATION
If thetongs are in theclosed / lockedposition, lightly
press the tongs together and push the 'Tongs Lock'
button. This will release the tongs and allow them to
open apart.
It is recommended that hair is washed prior to
straightening and be approximately 80% dry.
Connect the plugto an AS/NZS power supply socket
and switch on.
Switch thehair straightener on by pushing the
“ON/OFF” button on, the hair straightener plates will
heat up.
Comb your hair and hold a sectionthat is not wider
than5 cm for straightening.
Place it between the hair straightener plates and
press the handles firmly together.
Slidethe hair straightener down thelength of the hair
in a single motion(Not more than5 seconds) from
root to end, without stopping to prevent overheating.
To create flicks, turn thestraightener 180 degrees
(half-circle) inwards or outwards, whenit
reaches theendof the hair. Hold thestraightener in
that position for 2 to 3 seconds, and then release it.
Repeat above steps until you achieve the desired
effect.
Allow your hair to cool down. Do not comb or brush it
before it has cooled down, as this would ruin the
hairstyle youhave just created.
Switch off usingtheON/OFF Button to turn off the
appliance andremove mains plugfrom the supply.
5
1300 886 649
AU