Living Spaces 19CT039-13791A User manual

BOLT
BOLT
BOLT
A
A
B
B
C
Parts List：
1
1
2
2
4
4
16
4
METAL WASHER
PART NAME
REF REF
QTY PART NAME PART IMAGE
PART IMAGE QTY
(M6*55)
(M6*50)
(M6*35)
ALLEN WRENCH
SIDE BAFFLE
TABLE LEG
CLAPBOARD
DESKTOP
16
8
D
E
F
F
F
F
F
F
G
G
G
G
G
G
H
I
J
J
J
J
J
J
SANIBEL OUTDOOR COFFEE TABLE
19CT039-13791A
Assembly Instruction
PLASTIC BOLT
CAP
Diagram:

CC
F
F
F
F
F F
F
F
HH
H
H
I
I
II
J
J
J
J
JJ
J
J
SANIBEL OUTDOOR COFFEE TABLE
19CT039-13791A
Assembly Instruction
Step 1: Remove protective wrapping and lay all parts on floor. Indentify all parts
packed in Carton against attached parts list to make sure all parts are presented.
Step 2: Tip-Do not fully tighten the bolts until the components are fully assembled.
Step 3: Take out the table foot (C) and align it with the screw hole of the table
top (A), use the washer (F) screw as shown in the figure (G) and PE cover (J).
Step 4: Pour the product on the ground, align the partition (B) with the lower hole
of the table leg (C), as shown in the figure use washers (F) and screws (G) on
the PE cover (J).
Step 5: Place the product sideways, and then take out the side baffle(D). Use
washers (F). screw (H). PE cover (J) to align the bottom hole position of the side
baffle with clapboard(B), and use washers (F). screw (I). PE cover (J) to align the
upper hole position of the side baffle with desktop(A).
Note: The user is responsible for ensuring that all parts are assembled and
Tighten correctly and safely.
Assembly Steps: