User manual
7
Before using for the first time
Prior to initial use, clean it by going through several boiling cycles, using clean water with each cycle and
filling the kettle to its upper marking, the water will reach boiling point after approximately 5minutes,
when the unit switches off automatically.
USE
1. o fill the kettle, remove it from the power base and open lid by pressing open lid button (4), fill with the desired
amount of water, and then close the lid. Alternatively, the kettle may be filled through the spout (10). he water
level should not exceed max marks or sit below min level.
NOTE: Do not fill the water over the maximum level, as water may spill out of the spout when boiling. Ensure that
the lid is firmly in place before plugging the power outlet.
2. Position the kettle on the power base.
3
.
Connect the plug into a power outlet. Select the temperature button (- or+), and then press down the On/off
button, the indicator will light up. hen start to boil the water, the kettle will switch off automatically once the water
has reached the selected temperature. (before the water boiled, if you press On/off button again, the electric kettle
stop working)
NOTE: Ensure that the lid is firmly closed, the kettle will not turn off if the water is hot or if the lid is opening.
4. Lift the kettle from the power base and then pour the water carefully.
5. he kettle will not re-boil until the switch is pressed again. he kettle may be stored on the power base when not
in use.
6. he kettle has five temperature levels (40 /60/ 70 /80/100). If you want to keep warm the water when the kettle is
working, you can press the → “ ” button→ “On/off” button then keep warm function starts.
NOTE:
1.
Keep warm function only works for 2 hours; Please clean the water by using a dry cloth when the
temperature button surface has water on!
2.
You can add the removable filter to prepare tea; be careful, the tea mustn’t boiled (100° C) .
BOIL-DRY PROTECT
Should you accidentally let the kettle operate without water, the boil-dry protection will automatically switch off the
power. If this occurs, allow the kettle to cool before filling with cold water before re-boiling.
CLEANING AND MAIN ENANCE
1. Make sure the appliance is unplugged from the supply socket and fully cooled down before
cleaning.
2. o clean the exterior surfaces, slightly wipe over with a soft damp cloth and dry thoroughly.
3. o clean the inner walls of the kettle, use a soft damp cloth or a soft brush to remove the residues
