Loggerflex bun Hygro Specification sheet
Quick Setup and Usage Reference
You may skip this manual by watching a YouTube clip on our website
1) Have your WiFi nameand password ready.
This is not necessary if using the WPS push button on your WiFi modem (router).
2) Visit http://www.loggermaster.com and click on “Start here” and create an account. Please do not
forget to confirm your email address toactivate your account.
3)Log in to your account,choose “my profile” set your time zone, email and mobile phone
5) Use the provided magnet,hold it (not sweep) over the centre ofyour bun for >3 seconds until you
hear along continuous beep.
Please note that “bun” will beep shortly as soon as itdetects the magnet but you need tohold the
magnet until you hear a long beep.
Note: Make sure that you are withinthe WiFi range you want to connect your “bun hygro” to it and
the WiFi isON.
6) You have 3 minutes to use your computer/mobile/tablet tosearch for a WiFi named “bun hygro”
and connect toit. Please note that this is an open network, no password required.
www.loggerflex.com.au
(02) 89714548 0404430358
4) Press from the top left corner, Enter your device’s “Serial number” and “DUID” (provided with
the device) and click on to register your bun.
Gen 2
10)Sweep (do not hold) the magnet over the centre ofyour bun.You will hear a short beep as soon
as the device detects the magnet and after approximately 12 seconds you will hear 4 short beeps that
means your bun has successfully uploaded its first measurements.
7) Open abrowser on the same device, type in 192.168.4.1 or
bun.hygro/ in the address bar. Awhite page will appear. Follow
one of the methods below:
A) Choose your place WiFi name from the list, Enter your
WiFi Password.Then press Connect.
B) Click on WPS button on the top right corner of the white
page, then Press the physical WPS push button on your
WiFi modem. Bun automatically connects to your WiFi
network. NO password is required.
8) Wait for few seconds to hear either:
www.loggerflex.com.au
(02) 89714548 0404430358
4 short beeps (like: - - - -)that means “bun” issuccessfully
connected to the Internet and activated.
OR
2 long beeps (like: _ _ ) that means something went wrong and
“bun” failed to connect. You should start over from the step 5.
Note: Before starting over, make sure that your WiFi name &
password are correct by re-connecting your phone/laptop/tablet to
Internet by re-entering your password.
9) Please apply following settings in Loggermaster via the Edit button
15 min
Record Interval:
Upload Interval: 24 hour
(ii) If there is NO Continuous WiFi in your area
15 min
Record Interval:
Upload Interval: On Demand
Note: You may set min/max limits for temperature/humidity to receive alarms via email or SMS.
(i) If there is a continuous WiFi in your area
Gen 2
Table of contents
