Louroe Electronics A-ML User manual

NOTE
A-ML Microphone is NOT recommended for outdoor use
or in areas with high moisture content.
A-ML
Microphone
Housing and
pre-amp
Microphone
Element
DESCRIPTION
A-ML
AUDIO MONITORING SYSTEM
INSTALLATION AND OPERATING INSTRUCTIONS
6955 VALJEAN AVE, VAN NUYS, CA 91406
PH: [phone] / FAX: [phone]
/ www.louroe.com[email protected]
®
The Model A-ML is an omni-directional, low impedance, electret condenser microphone with level audio. It is
housed in a high impact ABS dome designed for ceiling or wall mounting. Normal pick-up pattern is approximately
15' from the microphone location, all directions, or within 30' diameter circle. The unit comes with 20’ pre-made cable
with a stereo plug on one end that can be plug directly to the Audio Input of an IP camera.
mic
SPECIFICATIONS
Sensitivity
Frequency response
Output Impedance
Current drain
50 Hz to 8 kHz
Supply voltage
Microphone housing High impact ABS
Dimensions
Shipping Weight
Weight
4” "dia x 1 ½ H
1 lb
7.5 oz
-45 dB/pa
1kW
0.8mA
1.8Vdc to 4.5Vdc
A_ml_inst 12/14
Connections cable

INSTALLATION AND OPERATING INSTRUCTIONS
LOUROE ELECTRONICS 6 9 5 5 VA L J E A N AVENUE, VAN NUYS, CA 91406 TEL [phone] FAX [phone]
website: www.louroe.com e-mail: [email protected]
(818)
®
The Model A-ML is cylindrical, 4” dia. x 1½” H, and has four mounting holes for surface mounting to a
ceiling or other flat surface. It should be positioned so that the microphone is 4’ to 8’ from the area of
desired coverage.
ABCL
N
MICROPHONE CONNECTION
Connect the other end of the cable with a 3.5mm Stereo
Plug to the Audio Input of the IP camera.The camera
has to be configured to Mic level settings.
IMPORTANT NOTICE
When this equipment is used as part of an
audio monitoring system, the law requires
that the public be given notice of AUDIO
MONITORING ON THE PREMISES. A
decal notice is included with each
microphone shipped.
Federal Law References:
Federal Regulations, US Code, Title 18.
Crime and Criminal Procedure, Sec 2510.
AUDIO
MONITORING
On
These Premises
®
WARRANTY
LOUROE ELECTRONICS warrants that at the time of shipment products manufactured by LOUROE ELECTRONICS to be free of defects in material and workmanship.
Should a defect appear within one year (12 months) from date of shipment, LOUROE ELECTRONICS will, at its sole discretion, repair or replace the defective equipment.
This equipment shall not be accepted for repair or return without prior notification by LOUROE ELECTRONICS .
This warranty does not extend to any Louroe product that has been subjected to improper or incorrect installation, misuse, accident, or in violation of installation
instructions provided by LOUROE ELECTRONICS.
Returned shipments to LOUROE ELECTRONICS shall be at customer’s expense. LOUROE ELECTRONICS will return the equipment prepaid via best way.
®
®
®
®
®
®
MANUFACTURED
IN THE
MOUNTING INFORMATION
IP CAMERA
TO IP CAMERA AUDIO INPUT
BACK SIDE OF A-ML
A_ml_inst 12/14