LPKF ZelFlex ZR User manual

1 V1.00 © 2009
ZelFlex ZR
Double-sided mechanical stretching frame
Step by step User guide

2 © 2009
ZelFlex ZR
Frame without stencil

3 © 2009
ZelFlex ZR
Using the two hexagon-
headed screws, attach the
rear bar according to the
stencil length.

4 © 2009
ZelFlex ZR
Rear bar must be
parallel to the rear
frame profile.
Tighten the two hexagon-headed
screws.

5 © 2009
ZelFlex ZR
Unwind the nuts from the
stretching screws by about
10 mm.

6 © 2009
ZelFlex ZR
Unwind the nuts from the
rear bar by about 4 mm.

7 © 2009
ZelFlex ZR
Orient the stencil according
to the coding side (offset
for stencil cut-out on rear
bar).

8 © 2009
ZelFlex ZR
Insert the stencil on pins in rear
clamping bar and close it with
holding bar.

9 © 2009
ZelFlex ZR
Fasten the nuts on
clamping bar lightly.

10 © 2009
ZelFlex ZR
Unwind the nuts from the
front bar by about 4mm.

11 © 2009
ZelFlex ZR
Insert the stencil on pins in
front stretching bar and
close it with holding bar.

12 © 2009
ZelFlex ZR
Fasten the nuts on
stretching bar lightly.

13
Assembly of protect frame
Tighten the nuts of
stretching units evenly to
lightly tension of the stencil.
ZelFlex ZR
V1.00 © 2009

14
Assembly of protect frame
Tighten the nuts on both
bars normally.
ZelFlex ZR
V1.00 © 2009

15
Assembly of protect frame
The gap between locker on
the stretching screw and
the bar should be approx.
3 mm for required working
tension.
ZelFlex ZR
V1.00 © 2009

16
Assembly of protect frame
Frame with stretched
stencil from bottom side.
ZelFlex ZR
V1.00 © 2009

17
Assembly of protect frame
Your ZelFlex ZR frame is ready to use!
ZelFlex ZR
V1.00 © 2009

18
ZelFlex ZR
V1.00 © 2009
www.ZelFlex.com

19 © 2009
Thank you for your attention.
LPKF Laser & Elektronika d.o.o. · Polica 33 · 4202 Naklo · Slovenia
[email protected] · [e-mail]