www.lsmaterials.co.kr
LSUM 086R4C 0093F EA
User Manual
www.lsmaterials.co.kr
6. Output terminal connection
The LS 86.4V / 93F Ultracapacitor Modules are designed to connect directly to a
ring or a bus bar. The positive and negative terminals have each hole for the screw.
The positive terminal threaded size is M8 and negative terminal is M10. Wave
washers are required to ensure long term, reliable connections.
When tightening the terminal bolt, a torque of 20 N-m for the M8 bolt should be
used.(30N-m for the M10 bolt) Because the modules have a very low ESR, total ESR
will be affected by a ring lug, bus bar or torque. Therefore, it needs more attention to
assemble the modules. And appropriate protection and sealing should be used on
both module terminalsto avoid shock hazardsand corrosion.
Pin # Pin out Pin # Pin out
1 Not used 5 Not used
2 Not used 6 Not used
3 PT100 pin1 7 Not used
4 PT100 pin2 8 Not used
7. Output connector
- The output of connector is tabulated below.
<Fig. 4> Monitoring connector
