LST OP-12001 User manual

© LABOR STRAUSS SICHERUNGSANLAGENBAU GMBH • A-1231 WIEN • WIEGELESTRASSE 36 • TEL [phone] • FAX [phone]
[email protected] • WWW.LST.AT • ALL RIGHTS RESERVED
OP-12001_DBL_LST_EN_0804.PDF • PAGE 1
ABuilding Safety. Building Security.
Optical Smoke Detector
OP-12001
• Addressable conventional technology
• Individual detector addressing by
means of optional address module
• Optional connection of remote
indicator
• Extremely fl at design
• Sealed electronics
Description
The Optical Smoke Detector OP-12001 uses the scatte-
red light principle and was developed for the detection
of smoke particles in a wide range of fi re detection ap-
plications. The modern design of the sensing chamber
allows to reliably evaluate the characteristics of fi re.
Intelligent evaluation algorithms compensate for the
contamination of the optical measurement system,
thus keeping the response sensitivity of the detector
constant for a long time. In this way, false alarms can
be avoided to a great extent. If the contamination can
not be compensated any further, or if a fault occurs in
the measurement system, this is indicated by a yellow
fl ashing of the multicoloured status LED.
Addressable conventional technology is used for alarm
transmission to the fi re detection control panel. By
means of the optional Address Module NG60-1, each
detector can be addressed individually, thus allowing to
display the detector address, as well as an assigned
element text, on a suitable fi re detection control panel.
The detector can be attached to various bases and it
can be protected against theft.
Specifi cations
Operating voltage Supply through the detector line voltage
Current consumption typ. 65µA (quiescent)
Ambient temperature - 40°C to +70°C (no condensation or icing)
Relative humidity 0 – 98% (no condensation)
Dimensions ø × H 100 × 31 (mm)
Colour white
Weight 75g
Approval VdS G204039
Order number 241060
Order name Optical Smoke Detector/Conv./ORBIS/Apo OP-12001