Lumantek ez-SHV+ User manual

ez- MANUAL
UPDATED SEPTEMBER. 2018
OPERATION
MANUAL
ez-SHV+
SDI to HDMI
Converter with
Display and Scaler

REVISION NUMBER: 1.0.0
DISTRIBUTION DATE: NOVEMBER. 2018
Copy Rights
Copyright © 2006~2018 LUMANTEK Co., Ltd.
All Rights Reserved
This document contains information that is proprietary to LUMANTEK.CO., LTD. The information
in this document is believed to be accurate and reliable; however, LUMANTEK assumes no
responsibility or liability for any errors or inaccuracies that may appear in this document, nor for
any infringements of patents or other rights to third parties resulting from its use.
This publication may contain technical issues, inaccurate information or typos. These will be
revised in revised edition, if there is any. No part of this publication is subject to be reproduced,
stored in retrieval system, or transmitted in any forms, or any means without the prior consent
by Lumantek.
Trademarks
HD ENCODULATOR TM, SD ENCODULATOR TM LUMANTEK Logo, Mega CruiserTM, ORIXTM,
X-CruiserTM, DTA-PlusTM, Media BlasterTM, are Trademarks of Lumantek. Co., Ltd.
Any other trademarks than stated above in this document belongs to its pertinent corporation.
Warranty Period
Lumantek’s products comes with One(1) year limited warranty. Please contact below if you need
more information.
LUMANTEK CUSTOMER SERVICES
[email protected]
TEL: [phone]
FAX: [phone]

LCD Display
Lumantek's ez-SHV+ is an SDI to HDMI converter with Display and Scaler.
The ez-SHV+ does more than just coverting. Through its 2.7 inch TFT-LCD, it dislays the video input.
The display also shows eye pattern for video quality monitoring, resolution of incoming / outgoing
video, and approximate cable length relative to the quality of the video resolution and cable.
Features
①Inputs & outputs
Input: 1 x SD/HD/3G-SDI (BNC 75Ω)
Output: 1 x SD/HD/3G HDMI (Type A)
1 x SD/HD/3G-SDI loop (BNC 75Ω)
1 x Analog audio (3.5mm stereo jack)
②Supports SD/HD/3G
③TFT-LCD Display (2.7 inch)
④Push switch for mode change
Diagram
01. ez-SHV+ (SDI to HDMI Converter with Display and Scaler)
SDI IN
SDI OUT
HDMI OUT
AUDIO OUT
Scaler
DAC
HDMI TXSDI RX
5

02. Interface
SDI OUT
SDI Video loop output port
DIP Switch
Resolution and other settings switch
LCD
2.7inch
TFT LCD
DC Input
DC Power Input
+5V to +18V
MODE Switch
LCD Menu setting switch
HDMI OUT
HDMI Video output port
AUDIO OUT
Analog audio output port
SDI IN
SDI Video input port
Specifications
6

02. Interface
DIP Switch Settings
VIDEO OUT : Video output resolution (Position 1, 2, 3, 4)
- 720x480i@59.94 (DIP SW : 1111)
- 720x576i@50 (DIP SW : 0111)
- 1280x720p@50 (DIP SW : 1011)
- 1280x720p@59.94 (DIP SW : 0011)
- 1280x720p@60 (DIP SW : 1101)
- 1920x1080i@50 (DIP SW : 0101)
- 1920x1080i@59.94 (DIP SW : 1001)
- 1920x1080i@60 (DIP SW : 0001)
- [email protected] (DIP SW : 1110)
- 1920x1080p@24 (DIP SW : 0110)
- 1920x1080p@25 (DIP SW : 1010)
- 1920x1080p@29.97 (DIP SW : 0010)
- 1920x1080p@30 (DIP SW : 1100)
- 1920x1080p@50 (DIP SW : 0100)
- 1920x1080p@59.94 (DIP SW : 1000)
- 1920x1080p@60 (DIP SW : 0000)
RATIO : Video output screen ratio (Position 5)
- FULL 16:9 (DIP SW : 1)
- Latter 4:3 or Pillar Box (DIP SW : 0)
BRIGHTNESS : LCD brightness (Position 6)
- Dark (DIP SW : 1)
- Bright(DIP SW : 0)
7

1080P60
Output ResolutionHDMI output resolution
* Resolution configured
through DIP Switch
Input Resolution
SDI Input resolution
* Shown as “Unknown”
where there is no input.
* If input is 3G Level-B,
1080P60B will be displayed.
Input video
SDI input video display
* In case 3G-SDI Level-B is
inserted, color bar will
be shown instead
Input SDI Eye Pattern
Shows thick eye pattern
if input video signal quality
is poor.
Input cable length
Shows approximated cable length
in 3 stages (SHORT, MEDIUM, LONG).
* Please refer to the chart below
for your reference.
* Reference cable is
Belden 1694A cables.
SHORT MEDIUM LONG
0M 60M 120M max. 190M
3G-SDI
SHORT MEDIUM LONG
0M 80M 160M max. 280M
HD-SDI
SHORT MEDIUM LONG
0M 140M 280M max. 450M
SD-SDI
02. Interface
1080i30
SHORT
LCD Display
8

① LCD Display ON/ OFF
Turn off the display by pressing
and holding the mode switch
for less than 6 sec.
Turn on the display
by pressing the mode switch for
less than 6 sec.
02. Interface
LCD Display
9

Turn on the eye pattern
by pressing the mode switch
for less than 1 sec.
Turn off the eye pattern
by pressing the mode switch
for less than 1 sec.
② SDI input eye pattern ON/ OFF
02. Interface
LCD Display
10

Rotate to 180 degrees
by pressing and holding
the mode switch
for more than 6 sec.
Rotate to 0 degrees
by pressing and holding
the mode switch
for more than 6 sec.
③ LCD monitor rotation (by 0 or 180 degrees)
02. Interface
LCD Display
11

Adapter specifications
AC in : AC100 to 240V,50/60Hz
DC out : DC12V, 1A
03. Product Configuration
ez-SHV+ AC to DC adapter
12

Data Input
SDI Video Input: SD/HD/3G-SDI (BNC 75Ω) x1
Video Formats:
- 720x480i@59.94/60
- 720x576i@50
- 1280x720p@50/59.94/60
- 1920x1080i@50/59.94/60
- [email protected]/24/25/29.97/30
- 1920x1080p@50/59.94/60
(3G-SDI Level-B not supported)
Data Output
SDI LOOP Output: SD/HD/3G-SDI (BNC 75Ω) x1
Audio Output: Stereo Jack x1
HDMI Video Output: SD/HD/3G
(HDMI Type A) x1
Video Formats:
- 720x480i@59.94 (DIP SW : 1111)
- 720x576i@50 (DIP SW : 0111)
- 1280x720p@50 (DIP SW : 1011)
- 1280x720p@59.94 (DIP SW : 0011)
- 1280x720p@60 (DIP SW : 1101)
- 1920x1080i@50 (DIP SW : 0101)
- 1920x1080i@59.94 (DIP SW : 1001)
- 1920x1080i@60 (DIP SW : 0001)
- [email protected] (DIP SW : 1110)
- 1920x1080p@24 (DIP SW : 0110)
- 1920x1080p@25 (DIP SW : 1010)
- 1920x1080p@29.97 (DIP SW : 0010)
- 1920x1080p@30 (DIP SW : 1100)
- 1920x1080p@50 (DIP SW : 0100)
- 1920x1080p@59.94 (DIP SW : 1000)
- 1920x1080p@60 (DIP SW : 0000)
Connections
Power : DC Power Input (DC Jack) x1
DIP Switch : (6 Pole) x1 Video In/Out Resolution,
Video Output Ratio, LCD Brightness
MODE : (Push Switch) x1 LCD ON/OFF, Menu
Selection
Display
2.7 inch TFT LCD : Input Video Display, Input SDI
Eye Pattern,In/Output Video Resolution Display,
Input Cable Length
Electrical
Power Input: DC +5V to +18V
Power Consumption: 3W(max.)
Operation Temperature: 0~45℃
Physical
Dimension: 86.3 (H) x 57.2 (W) x 26.6 (D) (mm)
Weight: 0.3 kg (0.66 lb)
ez-SHV+
04. Technical Specifications
13

LUMANTEK CUSTOMER SERVICES
[email protected]
TEL(Dir) : [phone]
FAX: [phone]