Lumascape LS9120 User manual

IN0168 170511
www.lumascape.com.au
INSTALLATION INSTRUCTIONS
Lumascape
Brisbane Technology Park
18 Brandl Street, Eight Mile Plains, QLD 4113, Australia
Phone: [phone]
Fax: [phone]
Email: [email protected]
Web: www.lumascape.com.au
LABEL
Wiring Details
CE Color Code UL / ETL Color Code Designation
Green / Yellow Green Earth / Ground
Brown Black Active / Live
Blue White Neutral
Black Grey Data *
* Data wire must be appropriately insulated if not connected.
Operating voltage on this wire is 24 V. Incorrect wiring will
damage luminaire and void warranty. Do not Hi-Pot test.
L
N
Bootlace ferrules must be ued on all wires
when connecting in terminal blocks.
DANGER
ISOLATE LUMINAIRE FROM POWER
Failure to isolate power
supply before installation or
maintenance may result in
fire, serious injury, electric
shock, death and may
damage the luminaire.
Connecting the luminaire
incorrectly can lead to permanent
damage and void warranty.
WARNING
FACADE LIGHT
LS9120 / LS9140 Facade Luminaire
Warranty void if not installed as per installation instructions
MODEL LS9120 |LS9140
INSTALLATION TYPE Surface Mount
IP RATING IP66
SUPPLY VOLTAGE 110-240 V AC, 50/60 H
INSTRUCTIONS COVER Single Colour (dimming)
Color Changing
Tunable White
NO POWER
TOOLS
DO NOT USE SILICONE
ON OUTSIDE SURFACE
KEEP ELECTRONICS FREE
FROM DIRT AND MOISTURE
DO NOT HOSE OR
PREASSURE CLEAN
N653
Luminaire Cable
Connect to a suitable power
supply in accordance with
local wiring rules.
Allen Key
Use Allen key to lock luminaire tilt
into position after adjusting tilt.
45°
6.50
Ø15.00
Base View of Mounting Bracket
Washer Plate
Use washer plate when
attaching the mounting
bracket to an accessory
or when mounting to any
mounting surface using a
countersunk screw.
Mounting Bracket
Use to attach luminaire to
suitable mounting surface.
Note that mounting bracket
can be flipped upside down
if required for installation
purposes. Do not use
mounting bracket with
countersunk screws unless
using in conjunction with
washer plate.
Bracket Mounting Screw
Use screw to attach luminaire
to mounting bracket.

IN0168 170511
www.lumascape.com.au
WARNING - To reduce the risk of FIRE or INJURY:
1. Luminaires and transformers to be installed by licensed electrical contractors.
2. Luminaires to be used for intended purpose only.
3. Do not operate the luminaires with a missing or damaged parts.
4. Use only genuine Lumascape parts to replace damaged or missing components.
5. Refer to instructions for installation and operating requirements.
6. Ensure installation complies with local regulations
Voltage insulation test (megger) will permanently damage product and will void warranty.
SAVE THESE INSTRUCTIONS.
SAFETY INSTRUCTIONS
Questions?
Call [phone]
Email [email protected]
www.lumascape.com.au