Lunasea LunaSafe LL63 User manual

LunaSafe
Safety
Products
TM
www.lunasea.com1-800-272-0170
LL63
INSTRUCTIONS

The LunaSafe Safety product is not
intended as a life saving device. It is not
intended to replace any other safety
considerations; such as adult supervi-
sion, lifeguards, fences, gates, pool
covers, locks, and so fourth. The
LunaSafe Safety Product is intended to
be an additional layer of security to
protect your loved ones. It is important to
spend sufficient time in becoming
familiar with the operation of your
LunaSafe Safety Product and to properly
test the unit so that it adequately covers
all areas of the pool for the person(s) or
pet(s) you wish to protect.

Transmitter
Press once to turn on strobe.
Press again to turn on blue monitor light.
Press again to turn off.
When in blue monitor mode, blue LED will glow for approx
2 hours before automatically switching to strobe mode. You
can change back to monitor mode by pressing the button.
Strobe will be at full brightness for a minimum of 8 hours
even after the blue monitor mode is run for two hours after
full charge.
When in blue monitor mode, strobe will automatically start
when device is submerged in water and continue until
battery is depleted or user turns off via button push.
If unit is in off mode, strobe will automatically start when
device is submerged in water and continue until battery is
depleted or user turns off via button push.
Device charge time is approximately 1 hour 45 minutes to
full charge from being fully depleted. Less time is needed if
device has some charge left.
Any QI certified charger (similar to cell phone chargers) can
be used.
Transmitter Functions

Applying Graphic Label
Choose Graphic Label you would prefer.
Make sure the center and two holes where gold water
sensor pins will protrude are punched out.
Remove protective backer from label. Apply label to unit
making sure the gold pins push through the label
completely. Use your fingernail or dull blunt object to
secure around pins and on balance of label.
Test that sensor pins are not obstructed by wetting finger
and making contact across pins.
WARNING: LABEL CAN NOT BE REMOVED ONCE PLACED.
DOING SO WILL DAMAGE SEAL AND DEVICE WILL NO
LONGER BE WATERPROOF.
Holes Clear Remove Backer