AssemblyInstruction
NAMES AND FUNCTIONS OF PARTS
Seat (seat hook) coupling hole
Cold water inlet
Hot water
inlet
Temperature control knob
Water pressure control knob
Main body
Water spray outlet
Parts
15/16 9/16
15/16
9/16
9/16
TUBE 3M
LUXE
(with rubber washer) (with rubber washer)
TM
MB210
R
12
Connecting Cold Water Supply
Remove the seat by
unscrewing the seat.
Place the bidet on the
toilet. Align the seet
coupling holes.
Screw the seat back on
to the bidet and the
toilet.
3
4
4a 4b
4b: Shut off the
water supply.
Disconnect the
water connection
from the tank.
4b: Connect the
plastic T-adapter to
the water supply as
shown in figure 4b
7
Cut off flexibile tube according to bathroom dimen-
sions. One part will be connected to the cold water,
other will be used for hot water connection.
5
5a
5a / 5c: Please make sure
that there is a black
rubber washer inserted in
top of both T-adapter.
5b / 5d: If it is not already
there, please insert it as
shown in figure 5b / 5d
5b
5c
5d
6
6a 6b 6c
6a: Remove the wing
nut.
6b: Put plastic tube
through wing nut.
6c: Connect plastic
tube to tank.Tighten
wing nut back on to
the T-adapter.
*top of the
T- adapter should
connect with the
water tanks
