luxvision ET-800 User manual

Notication
Dear Users,
Thank you for your purchase of ET 800 Electric Table. Please take time to read our
user’s manual carefully before use.
This guarantees you to make full use of this unit and prolongs the operation life of
this unit.
Precautions
If you have detected abnormal heat, smoke, noise or smell, immediately stop using
the product.
In the event of an abnormality, turn off the power and disconnect the power plug from
the power socket. Continuing to use the product may result in electric shock or re.
Observe the instructions given below regarding the power cable:
• Be sure to use the supplied or specied power cable.
• Do not modify, forcibly bend, kink or pull the power cable.
• When disconnecting the power cable from the AC outlet, be sure to hold the cable
by the plug.
Pulling the cable may cause wire breakage or shot circuit, resulting in re or electric
shock.
• Do not connect or disconnect the plug of the power cable to/from the AC outlet
using wet hands.
Doing so may result in electric shock.
• Do not touch the product with wet hands while the power cable is connected
to the AC outlet.
Doing so may result in electric shock.
• If the product will not be used for a long period, disconnect the power cable
from the power source. Leaving the cable connected to the power socket for
a prolonged period will consume electricity and may result in heating.

1. Function Introduction
ET 800 Electric Table has novel appearance, satisfactory performance of manipulation,
lifting steadily and with large lifting range (63cm - 83cm).
The foot can arbitrarily x from left to right, and the table-broad also can arbitrarily
slide from left to right. And it can laying two instruments.
It is applicable for lots of usages, for example, computers and other medical equipment.
It has easy installation, for example the picture:
M8 hexagonal wrench key
M8*20mm hexagonal socket screw
M8*45mm hexagonal socket screw
M8 diaphragm
1 piece
4 pieces
4 pieces
4 pieces
2. Accessories
Four M8*20mm hexagonal socket screws
(plus diaphragm)
Four M8*45mm hexagonal socket screws
3

4
LUXVISION is not responsible or liable for indirect, special or consequential damages arising out of or in
connection with the use or performance of the product or damages with respect to any economic loss,
loss of property, loss of revenues or prots, loss of enjoyment or use, costs of removal or installation or
other consequential damages of whatsoever nature. Some states do not allow the exclusion or limitation
of incidental or consequential damages. Accordingly, the above limitation may not apply to you.
Every effort has been made to ensure the accuracy of this manual. However, LUXVISION, makes no
warranties with respect to the documentation and disclaims any implied warranties of merchantability
and tness for a particular purpose. LUXVISION, Inc. shall not be liable for any errors or for incidental or
consequential damages in connection with the furnishing, performance, or use of this manual or the examples
herein. The information in this document is subject to change without notice.