M7 PB-9006 User manual

User's Manual
PB-9006
RIVETER NUT ADAPTOR
5
3
1
6
4
2
PB-9006
Dimensions 59mm x172mm(2-11/32" x 6-25/32")
Weight 280g=0.62 lbs
Nosepiece M3 M4 M5 M6
Hex Shank 1/4" (6.35 mm)
Cordless Drill 12V 14.4V
Reversible electric Drill (Advice 500W)
Reversible pneumatic Drill (Advice 3/8")
Min. Torque Strength 15 Nm = 11 ft/Ibs
Max. rpm 1000 rpm
Remove the unit and the accessory out of the
packaging . keep packaging materials Out of reach of
children.there is risk of suffocation
1. Hex Shank 1/4 (6.35 mm)
2. Housing PA+GF
3. Nosepiece M3
4. Sight Window Blind Nut Loading
5. Nosepiece M4 M5 M6
6. Wrench 1PC
Please note the following safety instructions to avoid
malfunctions,damage or physical injury:
1.Please observe all safety notes of the used driving
tool(drill)
2.Always switch off the driving tool and pull the power
plug before maintaining the blind rivet attachment, e.g.
changing the nose pieces or when not in use.
3.Only use the blind rivet attachment as indicated in this
manual for setting blind nuts. The unit is not designed for
continuous, professional use.
4.Always secure the work piece.
5.Do not wear loose clothing or jewellry. Tie up hair or
clothing so it cannot get caught in moving parts.
6.Only use the blind rivet attachment with the included
nosepieces.
7.Should the unit become damaged do not use it and have
it repaired by a professional or contact our customer
support department. Do not disassemble the unit or try
repairing it yourself.
Saf ety Instructions
1. Thread the rivet nut onto the tool.
2. Position the rivet nut into the hole.
Ensure the drill is in forwards gear.
While holding the body of the
attachment to stop it from rotating, press
the trigger. This will fasten the rivet.
3. Change the drill to reverse then
press trigger. This will release the
tool from the rivet nut.
1
2
3
View the demonstration video at
www.mighty-seven.com
Please note the following safety instructions to avoid
malfunctions,damage or physical injury:
1. Please observe all safety notes of the used driving tool
(drill.)
2. Always switch off the driving tool and pull the power
plug before maintaining the blind rivet attachment, e.g.
changing the nose pieces or when not in use.
3. Only use the blind rivet attachment as indicated in
this manual for setting blind nuts. The unit is not
designed for continuous, professional use.
4. Always secure the work piece.
5. Do not wear loose clothing or jewellry. Tie up hair or
clothing so it cannot get caught in moving parts.
6. Only use the blind rivet attachment with the included
nosepieces.
7. Should the unit become damaged do not use it and
have it repaired by a professional or contact our
customer support department. Do not disassemble the
unit or try repairing it yourself.
8. Suitable for aluminium, aluminium / steel and all steel
rivets.
9. Not suitable for stainless steel rivets.
10. Not for use with impact drivers
or drills in hammer mode.