
3
www.macfaucets.com
123A
67
Before proceeding, refer to Page 2 for
mounting methods, and to page 4 for proper
installation of soap dispenser relative to faucet.
Insert spout shank through sink hole
Install Battery case holder onto wall
in a level horizontal position.
Place battery case inside of battery holder
so that case label is legible
Use proper tool to tighten lock nut
Careful not to damage hose & cable
Installations using 1 gallon soap container,
please proceed to page 7.
Insert sensor cable FIRST then hose into
tubular part of pump housing
Rubber washer
Sealing gasket
Spout
Spout Shank Lock nut
Lock nut
Sensor cable
Soap hose
4A
Align octagon detail of pump housing with
octagon ID detail of shank and push
5A
Fasten pump housing onto spout
shank by rotating plastic nut
by hand only. Do not overtighten
Skip steps 3B and 4B, go directly to 6 & 7
Rotate nut
by hand
Spout Mount Method. See page 2
3B
Mount wall bracket onto wall in a level
horizontal position. Follow arrows
showing UP side.
Wall Mount Method. See page 2.
Instructions 6 & 7 below for battery powered units only.
For AC powered units, skip 6 & 7. Go directly to page 5, step 8
4B
Install pump housing onto wall bracket
(insert AA into BB and push
enclosure down).
Insert AA into BB
pump housing
A
A
B
B
ALL PYOS INSTALLATION MANUAL
Deck Mounting Installation