Makita ML900 User manual

Rechargeable Flashlight
Power source Bulb Switch
Makita battery cartridge
9000 9 6 V Rocker type
(rechargeable Nc-cdl
500 mA ON-OFF
MODEL ML900
Dimensions Net weight
0 84 mm x 273 mm
(0 3-114" x 10 314") IO 6 Ibsl
260 g
INSTRUCTION MANUAL

Installing or removingbattery cartridge
NOTE
:
Before operation, charge the battery cartridge with Makita 9.6V Fast
charger.
To insert the battery cartridge, pull
out the
set plate, align the tongue
on the battery cartridge with the
groove in the flashlight handle and
slip it into place. Snap the set plate
back into place. Be sure to close the
set plate fully before using the flash-
light.
Switch action
To turn the flashlight on, press the
"ON" side of the switch.
Press the
"OFF" side to turn it off.
Condensina or disDersina liaht
- --
To cast a wide beam, turn the knob
so that the pointer points to the
For
a narrow spotlight beam, turn
the knob
so that the pointer points
to the
=w marking.
marking.
Stand
The stand allows the flashlight to
be positioned
at a convenient up-
ward angle.
2

MAINTENANCE
CAUTION :
Always be sure that the flashlight is switched off and the battery cartridge
is removed before attempting to perform inspection or maintenance.
Replacing light bulb I
Turn the ring counterclockwise and
remove the ring, reflector and bulb
together. Pull the bulb holder out
of the reflector. Pull the bulb out
of the bulb holder after turning the
bulb slightly clockwise.
To install a new bulb, follow the re-
moval procedure in reverse. There
are three notches in the bulb holder.
Set the bulb in the center notch.
Bulb holder
rr
Set the bulb here.
CAUTION :
0 Replacement light bulbs are readily available from your Makita dealers,
or Makita Authorized or Factory Service Centers. Always specify bulb
type
(9.6 V, 500 mA).
*Never attempt to short the bulb I I
3

Cleaning
Use a cloth dampened in a mild detergent to clean off the flashlight from
time to time. Then wipe dry with
a dry cloth. Benzine, thinner and other
volatile agents will damage the plastic,
so never use them.
To maintain product SAFETY and RELIABILITY, repairs, maintenance
and adjustment should be perfomed by Makita Authorized or Factory
Service Centers, always using Makita replacement parts.
OPTIONAL ACCESSORIES
The accessories listed in this manual are available at an extra cost from your
Makita Distributor or Makita Factory Service Center. Service centers are listed
on the warranty card packedwith your tool.
Signalcap
Strap
Lanyardset
Recycling the battery
The only way to dispose of a Makitabatteryis to recycleit.
The law prohibitsany other method of disposal.
To recyclethe battery:
1. Remove the batteryfrom the tool.
2. (a) Takethe batteryto your nearest Makita Factory
Service Center.
@
Ni-Cd
or I
(b) Takethe batteryto your nearest MakitaAuthorized
Service Center or Distributorthat has been designated as a Makita
battery recyclinglocation.
Callyour nearestMakitaServiceCenter or Distributor to determine
thelocationthatprovidesMakitabattery recycling.Seeyour local
yellow pages under ‘Tools
- Electric. ”
Makita Corporation of America
Buford, GA
MCA-4193 883565CO67
PRINTED IN USA
1995-8-4D