7ENGLISH
* The test condition of recommended practical operation
meets EN 62841-2-6, except for the following points:
• Feed force is applied to the switch handle (main
• The side grip/handle (auxiliary handle) is held to
keep balance of the tool.
NOTE: The declared vibration total value(s) has been
measured in accordance with a standard test method
and may be used for comparing one tool with another.
NOTE: The declared vibration total value(s) may also
be used in a preliminary assessment of exposure.
WARNING:
-
WARNING:
Be sure to identify safety measures
-
-
For European countries only
The EC declaration of conformity is included as Annex A
to this instruction manual.
SAFETY WARNINGS
General power tool safety warnings
WARNING: -
with this power tool. Failure to follow all instructions
-
The term "power tool" in the warnings refers to your
mains-operated (corded) power tool or battery-operated
(cordless) power tool.
ROTARY HAMMER SAFETY
WARNINGS
1. Exposure to noise can
cause hearing loss.
2.
tool.
3.
-
Cutting accessory contacting a "live"
wire may make exposed metal parts of the power tool
"live" and could give the operator an electric shock.
rotary hammers
1. Always start drilling at low speed and with the
At higher
speeds, the bit is likely to bend if allowed to rotate
freely without contacting the workpiece, resulting
2.
Bits can
bend, causing breakage or loss of control, result-
Additional safety warnings
1.
-
padded gloves.
2.
operation.
3. Under normal operation, the tool is designed
operation.
4.
used for a long time, let the tool warm up for
5.
6.
7. Keep hands away from moving parts.
8. Do not leave the tool running. Operate the tool
only when hand-held.
9. Do not point the tool at any one in the area
injure someone seriously.
10.
11.
-
safety data.
12.
SAVE THESE INSTRUCTIONS.
WARNING:
serious personal injury.
