Makita LS0810 Manual

This machine is the desktop miter saw having the link
function(interlocking function) for the handle and the safety
cover. If the handle is lowered(start to cut), the safety cover will
start to open even if it does not touch the material, and it will be
opened up to the necessary angle without damaging the
material. Except that the open/close function of the safety cover
is different, all other features are same as LS0800, M241. M242
or the sister version of the LS0810 comprises the motor coated
with the light green color in general. Note that only the one
coated with the red color for exclusive export to America and
Canada is manufactured so far.
Voltage (V) Current (A) Cycle (Hz) Continuous
rating input(W) Rated output(W) Max. Output(W)
100 11.0 50/60 1050 620 810
115 7.3 50/60 800 440 860
200 5.5 50/60 1050 620 810
220 3.8 50/60 800 440 860
230 3.7 50/60 800 440 860
240 3.5 50/60 800 440 860
*All the main functions are same as LS0800-M241.
No Load Speed(min.) Rotation per minute 5000/min.
Inner dia 25mm, 25.4mm
domestic 200-216mm
Saw blade(mm) Outer dia. export 200-210mm
55mmx130mm
55mmx95mm
Max. cutting capacity(mm)
(When outer dia. of a saw blade
is 210mm)
52angle cutting in height,
in width 55mmx81mm (when the stiffening
plate with thickness of 3 mm is
placed between the guide rule and
the material)
Net Weight 5.6kg
domestic 5m
Cord length(m) export 2.5m
Holder assembly --- One set(for receiving the lengthy material)
Dust bag assembly --- One set
Box wrench 9 --- One piece(for detaching the saw blade)
Vice assembly --- One set(only for export)
(Same as LS0800, M241.)
The standard equipment for the tools shown may differ form country to country.
45angle cutting in height,
in width
Right angle(0) cutting in
height, in width
Specifications
Standard equipment
385
270
390
CONCEPTION AND MAIN APPLICATIONS
LS0810
Models No.
New Tool
TECHNICAL INFORMATION
Description MAKITA 210mm(8-1/4") Miter saw

Distributable ruler assembly(only for domestic)
Vice assembly(only for domestic)
Table set parts.
Saw blade (Same as LS0800, M241): Chip saw(No.210-11B18-teeth), Chip saw(No.210-11C40-teeth), Chip
saw(No.210-11E80-teeth), Combination(No.210-7A30-teeth)
* If the up/down motion of the handle becomes heavy due to the insufficient
turning of the ring 8 mounted near the center of the safety cover, repair in
the following orders. Disconnect the + pan head screw M6 and clean the
dust accumulated inside the ring 8 and on the + pan head screw and flat
washer 6, lubricate the oil, and then assemble. Do not strongly fasten the
screw in this case, which may potentially damage the female screw. The
screw should be fastened in a degree like fastening the normal M4
screw.(fastening torque : 10-15 kgf-cm)
* Others are same as LS0800, M241.
Safety cover
Flat washer6
Ring 8
+ pan head screw M6
Optional accessories
Repair