Mangar International Leglifter User manual

user instructions
Leglifter
Simple solutions for everyday independence

Simple solutions for everyday independence
2 3
Leglifter
The Leglifter by Mangar International enables people to raise their legs onto the bed independently or
with minimal assistance. Power is provided by the Mangar International Airo compressor.
PLEASE READ the separate Airo compressor instructions before using your Leglifter. When properly
maintained, the Leglifter will give many years of trouble free service.
• Ensure that you have read and fully understand these and the separate Airo compressor user
instructions before using the equipment.
• Only use a Mangar International air supply to inate the Leglifter.
• Ensure that the Leglifter does not come into contact with sharp objects.
• Ensure that the Airo compressor, air hose and hand control are positioned so as not to present a
tripping hazard.
• Do not operate the Airo compressor in the presence of ammable anaesthetic mixtures with air,
oxygen or nitrous oxide, as these mixtures can create a combustible environment leading to the
potential for re or even an explosion in the presence of a spark.
• Ensure that when in use, the Airo compressor, the hand control lead and air hose are laid out in
such a way as to avoid any risk of tripping or strangulation.
• Do not allow children to play with the Leglifter or Airo as operation of the equipment in an
uncontrolled or unsupervised situation may lead to personal injury and/or damage.
A
C
B
Standard Contents
1 x Leglifter (A)
1 x Fabric Cover (B)
2 x Fitting Straps (C)
1 x User Instructions
WARNINGS

Simple solutions for everyday independence
2 3
Leglifter
Standard tting instructions
• Fit the looped end of each strap around the
legs, castors or bed frame on the opposite side
of the bed (A g. 1) and pass the straps under
the mattress.
• Fit the hook of each strap onto the Leglifter
ap (B g.1) and position the Leglifter loosely
alongside the bed, clear of any obstacles such
as a bedside table.
• Tighten the straps to pull the edge of the ap
(‘Vee’ of deated Leglifter) under the mattress
by approximately 1 to 2 ngers width (C g.2).
• Connect the Leglifter air hose and hand control
(D g.3) to the Airo as indicated in the separate
Airo compressor user instructions.
• Test that the Leglifter inates to fully vertical
against the mattress and further tighten the
straps if necessary.
NOTE: Upon nal adjustment, the edge of the
ap settles to sit on the frame/divan (under the
mattress) by about 1 to 2 ngers width. This will
vary according to bed type e.g. divan, sprung
divan, narrow framed bed.
• Place the Airo compressor by the side or
under the bed in an out of the way position.
2
3
1
A
B
D
1 to 2 ngers
width
‘Vee’
C

Simple solutions for everyday independence
4 5
Leglifter
Fitting instructions (Proling Beds)
The exible construction of the deated Leglifter
makes it ideal for use with most types of proling
bed. However, please carefully follow these
guidelines to avoid any conict with moving
sections of the bed.
• Remove the mattress from the bed.
• Raise and lower the backrest and legrest
sections of the bed to identify strap positions
which best avoid chang/fouling of the straps.
• On the opposite side of the bed to where the
Leglifter is to be tted, secure the loop end
of each strap to the inner frame as indicated
(A g.4). NOTE: Wrap the strap around the
frame several times so as to shorten the strap
length, allowing the adjuster buckle to lie near
the centre line of the bed.
WARNING: When tting to a bed with a Low/High
function, ensure that the straps are attached to the
frame which moves up and down.
• Hook the two straps onto the ap of the Leglifter as indicated in (B g.4) and pull on the strap at the
adjuster buckle to draw the ‘Vee’ of the deated Leglifter inwards over the bed frame and under the
mattress by about 1 to 2 ngers width (C g.5).
• Raise and lower the backrest and legrest sections of the bed, checking to ensure that the straps do
not interfere with the bed’s functions.
• Ret the mattress.
• Connect the Leglifter to the Airo compressor and with the backrest and legrest sections of the bed
in the horizontal position, test that the Leglifter inates to fully vertical against the mattress. Tighten
the straps further if necessary. Upon nal adjustment, the edge of the ap settles to sit on the frame
(under the mattress) by about 1 to 2 ngers width.
NOTE: Normally, the Leglifter should be operated with all bed sections in the horizontal position. If
necessary, the backrest can be raised up to 45° to assist upper body stability while the legs are raised.
WARNINGS:
• Do not operate the Leglifter when the bed’s legrest is raised.
• Do not raise the bed’s legrest when the Leglifter is inated.
• Always deate the Leglifter after the legs have been safely positioned on the bed.
NOTE: Where tted, any integral cotside on the transfer side of the bed must be removed to permit
effective tting and operation of the leglifter.
4
A
B
5
CNOTE: If the bed sections are of
metal grid construction, ensure the
strap hook has its open side facing
upwards, to avoid fouling the grid.

Simple solutions for everyday independence
4 5
Leglifter
Operating instructions
• Sit on the bed at your normal entry point and
as far across the bed as possible. Angle your
legs towards the foot of the bed as far as is
comfortable (g. 6). If possible, use one arm
for support as illustrated, until you are ready to
lie down. Some clients prefer to use a bed lever
for this purpose.
• To lift your legs onto the bed, press ‘up’ on the
hand control. Release the ‘up’ button to stop at
the half-way stage and/or any convenient point
and adjust your position to improve the angle
of your legs (g. 7).
• Fully raise the Leglifter, allowing your legs to
slide along the cushion and gently drop onto
the bed (gs. 8 & 9).
• Deate the Leglifter by holding the ‘down’
button for a few seconds; release the button
and the Leglifter will carry on deating.
6
7
8
9

Simple solutions for everyday independence
6 7
Leglifter
Cleaning
routine cleaning
• Remove the cover and inate the Leglifter. Sponge clean with a non abrasive proprietary
liquid cleaner or disinfectant and dry thoroughly. Do not dry using hot air.
• The cover can be machine washed up to 40°C; low heat tumble dried and medium heat ironed. Do
not dry clean or use bleach.
disinfection
• The cover should be removed and the Leglifter fully inated. The Leglifter should be pre-
cleaned by washing with detergent and water and then disinfected using a 1:10 solution of
household liquid bleach and water (1 part bleach to 10 parts cold water). Leave the solution
on the HPL for approximately 10 minutes before thoroughly rinsing off with clean cold water.
Do not dry using hot air.
Storage
Ensure that the Leglifter is thoroughly dry before storing. Store deated.
Maintenance
• Periodically check the air hose for signs of damage or wear.
• Periodically check the tting straps for signs of damage or wear.
• Regularly launder the cover and allow to thoroughly dry before retting.
We recommend that a thorough examination of the Leglifter is carried out regularly (not to exceed 12
months). Please contact our Customer Service Department for further details or contact your local
supplier.
Repairs or servicing must only be carried out by your supplier or other authorised person.
57cm
124cm
90cm (min)
236cm (max)
10cm
Specications
(Inated) 124cm x 57cm x 10cm
Max. Air Pressure: 0,35 bar (5psi)
Max. Temperature: 50°C

Simple solutions for everyday independence
6 7
Leglifter
Leglifter serial number: ................................
Date of purchase: ................................
Invoice/Delivery note number: ................................
Mangar International reserves the right to alter product specications and/or any of the information contained within this document without notice.
Warranty
The guarantee is given against defects in material and workmanship and comprises piece, parts and
labour. The guarantee is not valid in the case of fair wear and tear, wilful damage, common neglect,
misuse or unauthorised alteration or repair by unqualied persons.
The following statements do not affect the consumer’s statutory rights. This product is sold on the
understanding that in the event of any defect of manufacture or material appearing within the warranty
period, the defect will be rectied free of charge providing that:
(a) Reasonable evidence is provided (e.g. purchase invoice, delivery note) that the claim is being made
within the warranty period.
(b) The defect is not attributable to accidental damage (either in transit or otherwise), misuse or
unauthorised repair.
We strive to provide our customers with reliable and durable products of the highest quality.
In addition to our standard warranty, and for added peace of mind, our Customer Service Department
offers an Annual Service and Clean package.
To nd out more about this service please call our Customer Service Department on Freephone 0800
2800 485.

Simple solutions for everyday independence
Mangar International
Presteigne, Powys, Wales, LD8 2UF
United Kingdom
tel: +44 (0)1544 267674
fax: +44 (0)1544 260287
e-mail: sales@mangar.co.uk
www.mangar.co.uk
www.mangarhealth.com MI0003 issue 10
(10/15)
Table of contents
Other Mangar International Medical Equipment manuals