Mark 7 PrimerSense 1050 User manual

PRIMERSENSE –1050/RL1100 INSTRUCTION MANUAL VERSION 1.1
1
101-1009: Mark 7® PrimerSense –1050/RL1100
`Instruction Manual V 1.1
Read this manual completely. Understand all safety and operating instructions. Failure to
comply with the warnings and instructions may result in serious injury, illness or death.

2
PrimerSense –1050/RL1100 Instruction Manual Version 1.1
Package Contents
Please review these contents and inform us right away if you appear to be missing any of these items:
Item No.
Description
QTY
1
PrimerSense –1050/RL1100
1
2
Thread Forming M2.26 X .91 T6 Drive Screw
2
3
8-32 Thread, 1-1/8" Long, Button Head Screw
2
4
#8 Washer, 0.172" ID, 0.375" OD
2
5
#8 Low Profile Hex
2
2
3
4
5

PRIMERSENSE –1050/RL1100 INSTRUCTION MANUAL VERSION 1.1
3
Set-Up Procedures:
Figure 1: New Style Left, Old Style Right
1. The PrimerSense mount works with both the new and old-style Dillon low primer alarms.
•Mounting on the new style primer alarm requires the Torx screws that thread into existing holes
inside (see below left).
•Mounting for the old style requires replacing the bottom 8-32 screws with the screws supplied
with the mount (see below right).
Figure 2: New Style mounted (left), Old style Mounted (right)
Note: It may be required to bend up the arm on the micro switch and to add a weight to the primer
follower to ensure the switches trigger correctly.

4
PrimerSense –1050/RL1100 Instruction Manual Version 1.1
2. Insert the PrimerSense into I/O Port #1 shown below then enable on the sensors tab and
perform a calibration before use.
Figure 3: Port Layout
Figure 4: Sensor Configuration Tab

PRIMERSENSE –1050/RL1100 INSTRUCTION MANUAL VERSION 1.1
5
Troubleshooting
Refer to the knowledge base section on our website under SUPPORT for troubleshooting articles relating
to setup and operation.
http://www.markvii-loading.com/knowledgebase
Please contact us for technical support
Phone: [phone]
Hours: 9:00am-4:30pm, ET, M–F