Marta MT-1549 User manual

MT-1549
Food processor with hand blender
User manual

Description:
A. Inching switch
G. “S” blade
B. Switch Ⅰ
H. Chopping bowl
C. Switch Ⅱ
I. Whisk holder
D. Motor unit
J. Whisk
D. Blender stick
F. Chopping bowl lid

Caution:
Please read the instructions carefully and completely before using the appliance.
1. Always unplug the appliance before assembling, disassembling, cleaning.
2. Before pluging into a socket, check whether your voltage corresponds to the rating label of the appliance.
3. Don’t plug the appliance into the power supply until it is fully assembled and always unplug before disassembling the appliance or handle the blade.
4. Don’t let the motor unit, cord, or plug get wet.
5. Never use a damaged appliance. If it has been damaged, please get it to approved service centre, checked or repaired.
6. If the supply cord is damaged, it must be replaced by approved service center.
7. Don’t let excess cord hang over the edge of the table or worktop or touch hot surface.
8. Don’t place the appliance in the hot ingredients.
9. The appliance is constructed to process normal household quantities.
10. Short-time operating. Use the appliance for no longer than 1 minute, for blender function.
11. Do not run the food chopper continuously for longer than 20 seconds leave to cool for 2 minutes in between each 20 seconds operation. Allow the appliance to cool
down to room temperature before continue operation.
12. If you press switch I, you can run the inching switch to meet your request. But the switch II is immutable.
13. Always disconnect the blender from the supply if it is left unattended and before assembling, disassembling or cleaning.
14. Switch off the appliance before changing accessories or approaching parts which move in use.
15. This appliance is not intended for use by children or other persons without assistance or supervision if their physical, sensory or mental capabilities prevent them
form using it safely. Children should be supervised to ensure that they do not play with the appliance.
16. Never use accessories, other than those supplied with the appliance
17. Children should be supervised to ensure that they do not play with the appliance.
18. If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.

How to use the hand blender
The handblender is perfectly suited for preparing dips, sauces, soups, mayonnaise and baby food as well as for mixing and milkshakes.
1. Turn the plastic or stainless steel blender stick on the motor unit until it locks.
2. Introduce the hand blender in the vessel. Then choose speed “1”-“5” ( or press the switchⅠor switchⅡto operate it).
3. Turn the blender stick off the motor unit after use.
You can use the hand blender in the measuring beaker and just as well in any other vessel.
4. Caution:the blade is very sharp!

How to use the chopper
1. Chopper is perfectly suited for hard food, such as chopping meat, cheese, onion, herbs, garlic, carrots, walnuts, almonds, prunes etc.
2. Don’t chop extremely hard food, such as ice cubes, nutmeg, coffee beans and grains.
Before chopping…
1. Carefully remove the plastic cover from the blade. Caution: the blade is very sharp! Always hold it by the upper plastic part.
2. Place the blade on the center pin of the chopper bowl. Press down the blade and lock bowl. Always place the chopper bowl on the anti-slip base.
3. Place the food in the chopper bowl.
4. Place the chopping bowl lid on the chopper bowl.
5. Turn the motor unit on the chopping bowl lid until it locks.
6. Choose speed “1”-“8” and press switchⅠor switchⅡto operate the chopper. During processing, hold the motor unit with on hand and the chopper bowl the other.
7. After use, turn the motor unit off the chopping bowl lid.
8. Then remove the chopping bowl lid. carefully take out the blade.
9. Remove the processed food from the chopper bowl.

How to use the whisk
Use the whisk only for whipping cream, beating egg whites and mixing sponges and Ready-mix desserts.
1. Inset the whisk into the whisk holder, and then turn the gear box on the motor unit until it locks.
2. Place the whisk in a vessel and only then. Choose speed “1”-“5” and press the switchⅠor switchⅡto operate it.
3. Turn the gear box off the motor unit after use. Then pull the whisk out of the gear box.
Cleaning
Cleaning the motor unit and chopping bowl lid only with a damp cloth only. Do not immerse the motor unit in water!
1. All other parts can be cleaned in the dish washer. However, after processing very salty food, you should rise the blades right away.
2. Also, be careful not to use an overdose of cleaner or decalcifier in your dishwasher.
3. When processing food with color, the plastic parts of the appliance may become discolored Wipe these parts with vegetable oil
before placing them in the dishwasher.
4. The blades are very sharp, please attention.
5. Unplug the appliance before cleaning.

Processing Guide (for 500ml chopping bowl)
Food
Maximum
Operation time
meat
300g
15sec
herbs
50g
10sec
nut, almonds
150g
10sec
cheese
100g
10sec
bread
80g
10sec
onions
200g
10sec
biscuits
150g
10sec
soft fruit
200g
10sec
SPECIFICATION
Power supply
Power
Net weight / Gross weight
Package size (L хW хH)
Producer:
JIANGSU BETTER ELECTRIC CO.,LTD.
ADD: 11#HUI HAI ROAD, BIN HAI ZONE, QI DONG, JIANG SU,
CHINA
Made in China
220-240 V, 50 Hz
700 W
1,8 kg / 2,1 kg
285 mm x 164 mm x 239 mm
WARRANTY DOES NOT COVER SUPPLIES (filters, ceramic and non-stick coating, rubber seals, etc.)
Production date is available in the serial number located on the identification sticker on the gift box and/or on sticker on the device. The serial number consists of 13 characters, the 4th and 5th
characters indicate the month, the 6th and 7th indicate the year of device production.
Producer may change the complete set, appearance, country of manufacture, warranty and technical characteristics of the model without notice. Please check when purchasing device.