Martin Universal Design GRANDEUR 91-02606115 User manual

GRANDEUR Model’s
91-02606115 & 91-02609115
IMPORTANT NOTICE
PARTS
K [6] M6X25 Hex Head Screws
4
11/2013

P lace 5-s ta r bas e (E ) face down
and pus h [5] cas tors (C ) into each
position.
1.
C
E
T HIS S T E P IS ONLY F OR
MODE L 92-02606 ONLY.
B efore a ttaching foot ring (F ) to
cylinder (B ). B egin by loos ening the
knob on the foot ring and make sure
the plas tic ringis ins erted properly,
by making s ure the cut ends of the
insert run parallel with the weld on
the inside of the foot ring hole. The
insert should be already in the foot
ring. NO TE : T HIS MUS T B E
P O S IT IONE D P R O P E R LY TO
AL LO W T HE C Y LINDE R TO S LIDE
T HR O UG H T HE INS E R T E AS ILY.
knob on foot ring
C ut ends of plas tic ins ert mus t
run parallel with the weld.
weld
S lide cylinder down through foot
ring and tighten knob. After chair is
ass embled completely, you may
adjus t foot ring to desired height.
2.
3.
P LE AS E NOT E : If you have model
number 92-02609, your ass embly
will be the s ame but ins tea d of foot
ring you will need to place black
bellows over top of cylinder after
inserting cylinder into base.
Insert wider end of cylinder into hole
in base, as shown above.
Model #
92-02609
Model #
92-02606
4.
Attach mechanism (A) to s eat (H)
using [4] M6x20 s crews (J ).
S ee picture above for s peci ed
locations that are circled. Tighten
with hex wrench.
H
A
5.
6.
Attach backres t (G ) to s ea t
mechanis m (A), by inserting backres t
support bar into oval hole in
mechanism. Tighten knob on
mechanism to s ecure.
G
A
Attach a rmres ts to bottom s ide of
s eat. E ach Armres t (M) us es [3]
screws (M6x25) on each arm.
7.
M6x25
S crew
Armres t
bracket
S eat
B ottom
Attach s ea t/backres t/a rmres t
ass embly to cylinder by inserting
top of cylinder into hole on bottom
of s eat mechanism. Weight of s itting
on seat will s ecure seat as s embly to
cylinder.
NOTE: 2 Paddles below seat are for seat
height adjustment & Backrest tilt adjust-
ments.
NOTE2: PERIODIC RE-TIGHTENING of Armrests
screws may be needed throughout use of
chair over the years.
8.
M6x25
M6x25
M6x25
11/2013