Martin Universal Design U9102 User manual

4444 Lawton Avenue, Detroit, MI 48208 USA • Tel:[phone]/Fax:[phone]
Email: [email protected] • visit us at www.MartinUniversalDesign.com
09/2011- RPI
Kids’ Dual Art Center Assembly Instructions
Model # U9102
Parts List
A) 1 ea Black Tray
B) 1 ea. Wooden Dowel Rod
D) 1 ea. Paper Roll - not pictured
E) 4 ea. Bottom Legs
F) 4 ea. 3/16” x 2 “ Bolts
G) 4 ea. 3/16” x 2 1/2” Bolt
H) 8 ea. 3/16” Flat Washer
I) 8 ea. 3/16” Wing Nut
J) 2 ea. Brackets
K) 4 ea. 5/8” Phillip Head Screws
L) 1 ea. Upper Easel Assembly
PLEASE NOTE:
All holes drilled to close tolerances for
maximum rigidity. It may be necessary to
tap bolts in place with a hammer.
PERIODIC RE-TIGHTENING WILL
ASSURE A STURDY PRODUCT.
(A) Black Tray
1 each
(E) Bottom
Legs
4 each
(F) 3/16” x 2”
Bolts
4 each
(G) 3/16” x 2-1/2 ”
Bolts
4 each
(K) 5/8” Phillip
Head Screws
4 each
(H) 3/16”
Flat Washer
8 each
(I) 3/16”
Wing Nut
8 each
(J)
Bracket
2 each
(B) Wooden
Dowel Rod
1 each
(L) Upper Easel
Assembly
1 each
WARNING:
CHOKING HAZARD - small parts
Not for children under 6 years
!
I M P O R T A N T !
If you have any difculty assembling your Kids’ Dual
Art Centers or need customer service assistance,
Please call: Martin Universal Design, Inc.
Customer Service Hot Line at [phone]
If you need additional parts, it is not necessary to
contact your dealer, our Customer Service Rep. will
forward them to you immediately.
Made in China
1

4444 Lawton Avenue, Detroit, MI 48208 USA • Tel:[phone]/Fax:[phone]
Email: [email protected] • visit us at www.MartinUniversalDesign.com
09/2011- RPI
Kids’ Dual Art Center Assembly Instructions
Model # U9102
TO ASSEMBLE:
1. Attach 2 bottom legs (E) to green
chalkboard side of upper easel
assembly (L), using 4 ea. 3/16” x 2”
bolts (F) and tighten with washers
(H) and wing nuts (I). See FIG 1.
NOTE: Make sure the same hole
is used on each leg for proper
height. i.e. if you use the middle
hole on one leg use the middle
hole on all legs.
2. Attach 2 bottom legs (E) to white
board side of upper easel assembly
(L), using 2 ea. 3/16” x 2 1/2” bolts
(G), insert these bolts into holes near
bottom of white board, tighten with
washers (H) and wing nuts (I).
See FIG 1B.
NOTE: Make sure the same hole
is used on each leg for proper
height. i.e. if you use the middle
hole on one leg use the middle
hole on all legs.
Enclosed are all the components necessary to assemble your new Deluxe Kids’
Dual Art Center #U-9102. Prior to assembly make sure all your parts are enclosed
by checking them against the parts list. Tools needed to assemble are a Phillips
Screwdriver and a Hammer.
F
FIG 1.
green
chalkboard
side
E
G
FIG 1B.
White
Drawing
Board Side
E
H
I
2

3. Attach plastic tray (A) to white
board side, using 2 ea.
3/16” x 2 1/2” bolts (G) into holes
below white board, rst insert bolt
through black plastic tray, then
through upper and lower leg and
then attach washer (H) onto bolt
and tighten wing nut (I).
Repeat with other side.
See FIG 2.
4. Attach brackets (J) to both sides
of easel using 4 ea. 5/8” phillip head
screws (K) into pre-drilled holes and
tighten.
Note: 2 screws per bracket.
See FIG 3.
5. Insert dowel rod (B) through
paper roll (D), then insert dowel rod
through top of easel holes in easel
side frame. See FIG 4.
See FIG 5 on last page for
exploded large view with part
identication & completed easel
illustrations.
Your child is now ready for hours of
Creative Enjoyment!
Kids’ Dual Art Center Assembly Instructions
Model # U9102
H
A
FIG 2.
I
G
K
J
K
4444 Lawton Avenue, Detroit, MI 48208 USA • Tel:[phone]/Fax:[phone]
Email: [email protected] • visit us at www.MartinUniversalDesign.com
09/2011- RPI
B
D
FIG 3.
FIG 4.
White
Drawing
Board Side
3

Kids’ Dual Art Center Assembly Instructions
Model # U9102
4444 Lawton Avenue, Detroit, MI 48208 USA • Tel:[phone]/Fax:[phone]
Email: [email protected] • visit us at www.MartinUniversalDesign.com
09/2011- RPI
B
F
G
E
A
E
E
F
K
J
IH
D
Complete easel with part
identication FIG 5.
Complete easel illustration.
FIG 6.
FIG 6.FIG 5.
WARNING:
CHOKING HAZARD - small parts
Not for children under 6 years
!
I M P O R T A N T !
If you have any difculty assembling your Kids’ Dual
Art Centers or need customer service assistance,
Please call: Martin Universal Design, Inc.
Customer Service Hot Line at [phone]
If you need additional parts, it is not necessary to
contact your dealer, our Customer Service Rep. will
forward them to you immediately.
4