Martin Yale my OFFICE PRODUCTS WC36Cart User manual

WC36
TRIMMER TABLE
ASSEMBLY INSTRUCTIONS
Model WC36Cart
Serial Number:
Date:

TABLE OF CONTENTS
ABOUT ........................................................................................................... 1
SPECIFICATIONS ................................................................................................ 1
FEATURES .......................................................................................................... 1
PARTS DIAGRAM ............................................................................................... 2
COMPONENTS ................................................................................................... 3
ASSEMBLY ..................................................................................................... 4
1. AFFIXING RIGHT LEGS ................................................................................... 4
2. AFFIXING LEFT LEGS ..................................................................................... 5
3. INSTALLING SUPPORT RAIL .......................................................................... 6
4. INSTALLING CASTERS ................................................................................... 7
5. ATTACHING THE SHELF ................................................................................ 8

ABOUT
Specifications
Sheet Capacity (20lb bond)
20 sheets
Board Thickness
.75 inches
Dimensions
47” x 25” x 36”
Weight
97.6 lbs
Features
• Self-sharpening blade
• Patented blade latch
• Finger guard
• Non-skid rubber feet
• Ergonomic, soft-grip handle
• Paper Clamp
• Made in the USA

2
Parts Diagram

3
Components

4
ASSEMBLY
1. Affixing Right Legs
Affix first two legs (blade side) as shown using (8) #8 x 1” LG wood screws. Be
certain to pre-drill 3/32” x 1 ¼” deep in the board has not been pre-drilled.

5
2. Affixing Left Legs
Loosely assemble the shelf with (8) #10 x 3/8 truss head screws and #10-32 lock
nuts. Then position the next two legs to the cutting table. Affix the remainaing two
legs with (4) #8 x 1” long wood scews, again pre-drilling pilot holes if necessary.

6
3. Installing Support Rail
Fasten support rail to both legs using (4) #10 x 3/8 LG screws and (4) lock nuts. Affix
the support rail to the cutting board with (2) #8 x 1” long wood scews, again pre-
drilling pilot holes if necessary.

7
4. Installing Casters
Using the (4) 5/16 lock washers and nuts, affix the two swivel casters to one end of
the table and the two locking casters to the other.
Again using the #10 x 3/8 LG truss head screws and lock nuts, affiz the folding shelf
brackets to the operator side of the cutting table.

8
5. Attaching the Shelf
Position the shelf onto the folding hinges and secure it in place with (4) #10 lock
nuts onto the under side.
Loosely attach the grip to the mounting brackets with ¼-20 button head screw.
Attache bracket to cart with #10 screws and lock nuts. Tighten the ¼-20 button
head screws to prevent the grip from turning.
Your trimmer table is now ready for use.

M-S0271011 R1 10-21
By Martin Yale Industries
251 Wedcor Ave. Wabash, IN 46992
my-officeproducts.com |martinyale.com
[e-mail] | 800-225-5644
For Product Registration and Warranty information visit
martinyale.com/register