Martin Yale 1628 User manual

Desktop Letter Opener
Model 1628
Operating Instructions
Warning: Never connect power to this product until you are ready
to use the letter opener. The AC outlet used for this machine must
be nearby and must not be blocked. This machine contains mov-
ing parts that can catch hair, loose clothing or jewelry. During
operation and maintenance, keep hair, loose clothing and jewelry
clear of moving parts. Disconnect the power cord from the wall
outlet before attempting any service to the unit, and before remov-
ing the cover for any reason.
Attention: For equipment that plugs in, the socket/outlet shall be
installed near the equipment and shall be readily accessible.
I n d u s t r i e s
MARTIN YALE
CAUTION
DO NOT insert thick
cardboard, metal, hard
paper, etc. into the letter
opener
DO NOT feed envelopes
fastened with staples or
paper clips.
DO NOT touch the cutters
with your fingers.
Parts List
Part No. Qty. Description
M-S162811 2 Envelope Exciter
M-S162812 3 Drive Belt
MRA161609 1 Lower Cutter Blade
MRA161610 1 Upper Cutter Blade
I n d u s t r i e s
MARTIN YALE
251 WedcorAvenue, Wabash, IN. 46992
Toll Free: 1.800.225.5644
Fax: [phone]
Email: [email protected]
Website: www.martinyale.com M-S027225

Unpack the unit and plug the power cord into a power outlet. The unit
should turn on when depressing the start button on the top cover and
shut off when releasing the start button.
NOTE: If unit jams during operation, unplug the unit and clear all
jams. Then reinstall the power plug.
Step 1. Prepare up to 10 standard envelopes to be opened by
tapping the top sealed flap side down firmly on desktop several times.
This will cause the envelope contents to slide to the opposite side of
that to be opened.
Step 2. Place up to 10 prepared envelopes onto the feed tray with the
bottom edges of the envelopes back against the opener housing and
also against the top cover that contains the START button.
Step 3. Momentarily depress the START button to begin the feeding
process. You may release the START button when envelopes begin
exiting the unit.
Step 4. Depending on the condition of the envelope edges and
flatness, the entire stack should automatically feed until the stack is
completed. However, under previously mentioned conditions of the
envelopes, you can depress the START button to begin feeding again
if it hesitated and did not complete the stack.
Step 5. Your stack of envelopes will be stacked on the right side of
the unit and the scrap is easily separated from your opened
envelopes. The cut edges of your envelopes are cut such that they
are unlikely to cut or injure fingers.