Matchmaster DigiMATCH 02MM-GX500 User manual

Step 1
Attach corner reector to boom.
See diagram.
Step 2
Cut the rubber boot seal
provided and slide onto
stripped cable as in diagram.
Step 3
Select connector provided.
(Suitable for RG6 or semi airspaced cable)
Place “F” connector on back to front and twist to ensure
that all braid is at. See diagram.
(For other cable types you will need to purchase the corresponding connector)
Step 4
Then insert cable into rear of connector and twist
connector clockwise until dielectric is ush with the bottom
nut as illustrated. Ensure that 2-3mm of centre core conductor
protrudes past the nut and that the braid makes contact
with the inner body of the connector.
Step 2A
Strip coax cable as shown in diagram
and feed through rubber boot seal.
Plastic Outer Case
Metal Braid
Dielectric
Metal Sheath Knurled Surface
Core
Conductor
02MM-GX500
UHF Ch (28-51) 18 Element TV Antenna with 4G Filter

Step 5
Select the UHF X-Dipole,
connect the downlead cable
just prepared to the
connector on the balun
marked "Output".
Step 6
Assemble 2 halves of boom together. See diagram.
Step 6a
Assemble “U” bolt and
tilt bracket onto the centre
of the boom. See diagram.
NB: In vertical polarized areas,
mount the 'U' Bolt in the
holes punched at 90° on
adjacent face of boom.
Step 7
Attach antenna to mast and
point to transmitter as in diagram.
Rotate antenna to achieve best results.
Attach cable to mast with UV grade insulation
tape or UV grade cable ties to support cable weight
and avoid damage to connection from wind
whiping cablefrom side to side.
Step 7A
For digital compatibility terminate cable into suitable “F” type splitters such as
07MM-GM02 or 07MM-GM04 or “F” outlet plates such as 05MM-WP01 or 05MM-WP11.
NB RG6 cable with aluminium foil and aluminium braid is ideal for digital reception.
N.B.2 If close to transmitter use DA-FLY2M Quad shield ylead to avoid interference.
Step 5A
Then slide rubber
boot seals into
position as
per diagram.
For any technical enquiries, please call Matchmaster TV Reception Systems on
Toll Free Aust: 1800-AERIAL (1800-237425) or Toll Free NZ: 0800-AERIAL (0800-237425)
Top edge of bracket hooks
over edge of boom
To Transmitter