Matchmaster DigiMATCH 03MM-DR3004 User manual

Step 1
Take the antenna boom out of the carton.
Swivel all elements 90 degrees to the boom
from the packed position till they 'snap lock'.
Step 2
Attach long loose element (900mm)
to boom using the hole at the end of
the boom behind the dipole.
Then attach the short loose element
(530mm) onto the other end of the
antenna boom.
Step 3
Strip coax cable as shown in diagram.
Step 4
Select connector provided. (Suitable for RG6 or semi airspaced cable)
Place “F” connector on back to front and twist to ensure
that all braid is at. See diagram.
(For other cable types you will need to purchase the corresponding connector)
DR3004 1-15
03MM-DR3004
VHF Ch (6-12) TV Antenna Installation Instructions

Step 5
Then insert cable into rear of connector and twist
connector clockwise until dielectric is ush with the
bottom nut as illustrated. Ensure that 2-3mm of centre
core conductor protrudes past the nut and that the
braid makes contact with the inner body of the connector.
Step 6
Assemble “U” bolt into boom.
See Fig 7. NB In vertical polarized areas,
you can use a 11MM-SM1-15 mount
(15" vertical stand off boom).
Step 8
Attach antenna to mast and point to
transmitter.The shortest elements
point to the transmitter.
Rotate antenna to achieve best results.
Attach cable to mast with UV grade
insulation tape or UV grade cable ties
to support cable weight and avoid
damage to connection from wind
whipping cable from side to side.
Step 9
For digital compatibility terminate cable into suitable “F” type splitters
such as 07MM-GM02 or 07MM-GM04 or “F” outlet plates such as 05MM-WP01 or 05MM-WP11.
NB RG6 cable with aluminium foil and aluminium braid is ideal for digital reception.
N.B.2 If close to transmitter use DA-FLY2M Quad shield ylead to avoid interference.
DR3004 1-15
Step 7
Connect cable to ‘F’ connector on balun, tighten
with ngers.
WARNING OVER TIGHTENING OF
CONNECTOR MAY DAMAGE CIRCUIT BOARD.
Slide boot seal over connector
for protection.
To Transmitter
Plastic Outer Case
Metal Braid
Dielectric
Metal Sheath Knurled Surface Core
Conductor
For any technical enquiries, please call Matchmaster TV Reception Systems on
Toll Free Aust: 1800-AERIAL (1800-237425) or Toll Free NZ: 0800-AERIAL (0800-237425)