Matchmaster DigiMATCH 03MM-DR3006P User manual

Step 4
Cut the rubber boot seal provided and slide onto
stripped cable as in diagram.
03MM-DR3006P
VHF Ch (6-12) TV Antenna Installation Instructions
Step 1
Take both halves of the antenna out of the
carton. Swivel all attached single elements
90 degrees to the boom from the packed
position till they ‘snap lock’. See diagram.
Step 2
The curved dipole needs to be
attached to the underside of the
boom at 90 degrees.
Step 5
Strip coax cable as shown in diagram and feed through
rubber boot seal. See diagram.
Step 6
Select connector provided.
(Suitable for RG6 or semi airspaced cable)
Place “F” connector on back to front and twist to
ensure that all braid is at. See diagram.
(For other cable types you will need to purchase
the corresponding connector)

Step 8
Attach nut of connector to “Female connector” on antenna
and tighten nger tight.
WARNING OVER TIGHTENING MAY DAMAGE CIRCUIT BOARD.
Slide boot seal onto balun.
Step 9
Assemble “U” bolt into boom. See diagram.
NB In vertical polarized areas,
you can use a 11MM-SM1-15 mount
(15” vertical stand off boom sold separately).
Step 10
Attach antenna to mast and point
to transmitter as per diagram.
Rotate antenna to achieve best results.
Attach cable to mast with UV grade insulation tape or
UV grade cable ties to support cable weight and avoid damage
to connection from wind whiping cable from side to side.
For digital compatibility terminate cable into suitable “F” type splitters such
as 07MM-GM02 or 07MM-GM04 or “F” outlet plates such as 05MM-WP01 or 05MM-WP11.
NB RG6 cable with aluminium foil and aluminium braid is ideal for digital reception.
N.B.2 If close to transmitter use DA-FLY2M Quad shield ylead to avoid interference.
For any technical enquiries, please call Matchmaster TV Reception Systems on
Toll Free Aust: 1800-AERIAL (1800-237425) or Toll Free NZ: 0800-AERIAL (0800-237425)
To Transmitter
Step 7
Then insert cable into rear of connector and twist
connector clockwise until dielectric is ush with the
bottom nut as in diagram. Ensure that 2-3mm of centre
core conductor protrudes past the nut.
Plastic Outer Case
Metal Braid
Dielectric
Metal Sheath Knurled Surface Core
Conductor