Matrix T5 User manual

Note: The Motor Fly Wheel and the Front Roller Pulley need to be in parallel. If not the Drive Belt will not run
straight and could cause damage to the belt or speed sensor.
Unit shown is a T5 model treadmill. The steps are the same for a T4 or T5x treadmill also.
1. Measure the parallel angle from the 2. The Motor Fly Wheel tolerance 3. If the tolerance is out of spec you
Front Pulley to the Motor Flywheel should be +/-.5mm gap will need to adjust the motor using
a 15mm socket and a long extension
on a ratchet.
4. Measure the parallel angle from the 2. The Motor Fly Wheel to Idler gap 3. If the tolerance is out of spec you
Motor Flywheel to the Idler should be 12mm +/-.5mm gap will need to adjust the Idler using a
5mm Allen Wrench on the Idler bolts
T
5 / T4 Drive Belt Alignment SOP Instructions
T
5
x
Drive Belt Ali
g
nment
S
OP Instructions
Tools Needed
1. Ruler or Jig
2. 3/8 Drive socket
3. 3/8 Drive Long Extension
4. 15mm Socket
5. 5mm Allen Wrench
6. Pry Bar
Installation Time:
Approximately 40 minutes
Installation Steps
1000311 Rev 3

1. To Adjust the belt use a prybar to 2. To adjust the front roller you will need to loosen the front roller bolts. The
pull up on the idler to release the Left side (pulley side) has a 5mm allen bolt and the Right side has a
tension. Now position the belt 8mm Allen bolt and a 15mm nut. Loosen these bolts and you can
correctly on the front roller pulley shift the Front roller side to side. Once in place tighten down.
and motor flywheel pulley.
3. You may need to loosen the rear 4. Insert the 8mm Allen bolt into the rear end cap and turn counter-
roller to loosen the belt. clockwise to loosen. You need to loosen the left and right sides.
Adjusting the Drive Belt & Front Roller