Mattel Tyco R/C Turbo Street Wheelie Cycle User manual

4
3
2
3
4
6
1
1
2
5
GET STARTED!
Your Turbo Street Wheelie Cycle™is a high performance
motorcycle that allows you to pull off outrageous “one touch”
wheelies. Plus, your Turbo Street Wheelie Cycle™has a
specialized stabilizer that allows for maximum stability for your
most radical stunts.
1.GET SET!
Hold the Turbo Street Wheelie Cycle™off the ground and hold
throttle button on transmitter.
Be sure to keep your fingers clear of the wheels at all times.
2.LAUNCH IT!
Gently hand-launch your vehicle.
I. CONTENTS/ FEATURES
• Turbo Street Wheelie Cycle™
• Transmitter
BIKE
1Rider Figure (not removable)
2ON/OFF Switch
3Battery Latch
4Battery Compartment
TRANSMITTER
NOTE: Your transmitter is equipped with a special automatic
ON battery-saving feature. Just turn your vehicle ON. push
either transmitter button and you will be able to run and
control your bike.
1Wheelie Stunt
2Forward
3Turn Left
4Turn Right
5Battery Compartment
6Antenna
II. QUICK START
Please read this Owner’s Manual thoroughly.
1. Start with a Fresh set of batteries.
2. Turn the bike switch ON. Press the transmitter controls to run
and control your bike.
3. When you’re done driving, turn the bike switch OFF. Remove
all the batteries for storage.
Keep these instructions for future reference as they contain important information.
IMPORTANT: Please read all “Consumer Information” before operating your vehicle.
ASST. R5381
R6462/R6463-0920
6+
CAUTION: Surfaces may become hot
and cause burns if electronics get wet. Do not
operate vehicle through water or snow.
FRONT BACK
TM
®

III. OPERATION
FORWARD WHEELIE STUNTS
LEFT TURN RIGHT TURN
IV. QUICK TIPS
1. When your bike starts to lose power, it may lose
functionality or performance. It’s time for fresh
batteries. Your bike’s running time may change
depending on your driving style.
2. Radio interference can make your bike run poorly.
Interference can be caused by other R/C vehicles
running on the same frequency, electrical wires,
large buildings, CB radios or other wireless gear.
Try to stay away from these!
3. Point your transmitter antenna upward. If your bike
gets too far away, it won’t work properly.
4. Don’t drive your bike through water or snow.
If your bike does get wet, wipe it with a towel and
allow it to dry completely.
5. Don’t store your vehicle near heat or in direct
sunlight. Always turn switch OFF and remove all
batteries for storage.
6. Keep the antenna in the right position to achieve
the best control range. After playing for some
time, the antenna may bend. Please re-adjust the
antenna if you find the control range is short when
the bike is in wheelie position.
r
q
t
ew
6
Make sure the antenna is kept in the right position to achieve the best control range

V. BATTERY INSTALLATION
Requires 4 AA alkaline batteries for the bike and 2
AA alkaline batteries for the transmitter. Batteries not
included.
BIKE
1. Turn your bike over. Pull out the wheelie bar. Then rotate the
battery latch to release the battery holder.
2. Lift the battery holder out of the bike.
3. Insert 4 AA batteries into the battery holder, with polarity (+/-)
as shown on the battery holder.
4. Replace the battery holder in the bike and rotate the latch until
it clicks shut, locking the battery holder in place.
TRANSMITTER
1. Use a screwdriver (not included) to unscrew the battery door,
remove the battery door.
2. Install two AA batteries with polarity(-/+) as shown inside the
battery compartment.
3. Replace the battery door.
2 x AA
1
2 3
4
2 x AA
1
2 3
4
CONSUMER INFORMATION
Adults, this toy is recommended for children 6 years of age and
older. To ensure that the child’s play is both safe and fun, please
review the operating instructions and these general safety rules
with the child.
Safety Tips
• NEVER drive your bike on streets! They’re for real cars!
• DO NOT pick up bike while in motion.
• Keep fingers, hair and loose clothing away from the tires and the
wheel hubs while the bike is switched ON.
• Adult supervision is recommended when this bike is being
operated.
• To avoid accidental operation, remove all batteries when not in
use. Always turn the vehicle OFF before removing batteries.
In exceptional circumstances batteries may leak fluids that can
cause a chemical burn injury or ruin your product. To avoid battery
leakage:
• Non-rechargeable batteries are not to be recharged.
• Rechargeable batteries are to be removed from the product before
being charged (if designed to be removable).
• Rechargeable batteries are only to be charged under adult
supervision (if designed to be removable).
• Do not mix alkaline, standard (carbon-zinc), or rechargeable
(NiMH) batteries.
• Do not mix old and new batteries.
• Only batteries of the same or equivalent type as
recommended are to be used.
• Batteries are to be inserted with the correct polarity.
• Exhausted batteries are to be removed from the product.
• The supply terminals are not to be short-circuited.
• Dispose of battery(ies) safely.
• Do not dispose of this product in a fire. The batteries inside may
explode or leak.
Battery Performance Note:
For best performance use regular or high-performance alkaline
batteries (where disposable batteries are called for). If your vehicle
is supplied with standard (carbon-zinc) batteries for initial use and/
or demonstration purposes, we recommend replacing them with
alkaline batteries when necessary. Battery life may vary depending
on battery brand.
VI. BATTERY SAFETY INFORMATION
Protect the environment by not disposing of this product
with household waste (2002/96/EC). Check your local
authority for recycling advice and facilities.
CAUTION: To prevent entanglement, keep hair away
from wheels.
a
b

COMPLIANCE WITH FCC REGULATIONS (VALID IN
U.S. ONLY).
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that
may cause undesired operation.
• This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if
not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
NOTE: Changes or modications not expressly approved by the
manufacturer responsible for compliance could void the user’s
authority to operate the equipment.
© 2009 Mattel, Inc. All Rights Reserved. Mattel, Inc. 636 Girard
Avenue, East Aurora, NY 14052, U.S.A. Consumer Relations
1-888-557-8926. Retain this address for future reference:
• Mattel U.K. Ltd., Vanwall Business Park, Maidenhead SL6 4UB.
Helpline 01628 500303. • Mattel Australia Pty Ltd., Richmond,
Victoria 3121 - Consumer Advisory Service: 1300 135 312.
• Mattel East Asia Ltd, Room 1106, South Tower, World Finance
Centre, Harbour City, Tsimshatsui, HK, China. • Diimport &
Diedarkan Oleh: Mattel SEA Ptd Ltd. (993532-P) Lot 13.5, Menara
Lien Hoe, Persiaran Tropicana Golf Country Resort, 47410 PJ. Tel:
03-78803817, Fax: [phone]. service.mattel.com