MaxiCosi ISOGO Specification sheet

Recline
Indicator
6
Pull
Recline seat for
infant use
Pull
Press
Loosen harness
2
Ensure the tension
indicators show green
14
click
Attach ISOGO
connectors
11
Open installation door
5
Pull
Push
Remove slack
12
Pull
Tighten the harness
23
Double check shoulder
height markers
24
Lift Smart Lock®handle
(use to hold door open)
6
Thread connectors
through belt path
9
1
Pull
Fully lengthen ISOGO
connector straps
10
Unbutton seat trim
4
Harness straps
in green zone
The shoulder
straps must be in
the slots which are
nearest the child’s
shoulders, but not
lower than the
child’s shoulders.
21
Place child in the
restraint
20
Store strap in storage
pocket
19
Rear Facing Mode
3
Raise headrest height
Engage
tether
Thread tether through
Smart Guide®
17 Remove
Slack
Remove slack from top
tether
18
Attach
Attach the top tether
strap
1615
Close installation door
and restore seat fabric
Engage harness buckle
22
click
Quick Setup with ISOGO
7
Open ISOGO storage
compartment
8
Unclip ISOGO
connectors & close door
13
Close Smart Lock®
Do not engage
conventional tether
position on both sides
of restraint.
Do not engage tether
on both sides of
restraint.
(if tted)

Rear Facing Mode
Pull
Press
Loosen harness
2
Ensure the tension
indicators shows
green on both sides
12
Pull
Tighten the harness
21
Open installation door
5
Double check shoulder
height markers
22
Lift Smart Lock®handle
(use to hold door open)
6
Remove
Slack
Remove slack from top
tether
16
Harness straps
in green zone
The shoulder straps
must be in the slots
which are nearest
the child’s shoulders,
but not lower than
the child’s shoulders.
19
Unbutton seat trim
4
Place child in the
restraint
18
Store strap in storage
pocket
17
Recline
Indicator
6
Pull
Recline seat for
infant use
1 3
Raise headrest height
Engage
tether
Thread tether through
Smart Guide®
15
Attach
Attach the top tether
strap
1413
Close installation door
and restore seat fabric
Engage harness buckle
20
click
9
click
Fasten the seatbelt
buckle
Remove Slack from Seatbelt
PullPush
10
Remove slack
11
Close Smart Lock®
7 8
Thread seatbelt through belt path
Do not engage
conventional tether
position on both sides
of restraint.
Do not engage tether
on both sides of
restraint.
Quick Setup with Seatbelt

Pull
Press
Loosen harness
2
Ensure the tension
indicators shows
green on both sides
14
Double check shoulder
height markers
23
Open installation door
5
Remove
Slack
Remove slack from top
tether
17
Unclip ISOGO
connectors
8
Harness straps in green zone
The shoulder straps
must be in the slots
which are nearest to
the child’s shoulders
but not more than
25mm below the
child’s shoulders.
20
Pull
Push
Remove slack. Ensure
both indicators are green
12
Lift Smart Lock®
handle (use to hold
door open)
6
Store strap in storage
pocket
18
Thread connectors
through belt path
9
Pull
Fully lengthen ISOGO
connector straps
10
Pull
Tighten the harness
22
Unbutton seat trim
4
Attach
Attach the top tether
strap
16
Place child in the
restraint
19
Recline
Indicator
5
Pull
Convert seat to
forward facing mode
1 3
Raise headrest height
15
Close installation door
and restore seat fabric
Engage harness buckle
21
click
Attach ISOGO
connectors
11
click
Quick Setup with ISOGO
Forward Facing Mode
7
Open ISOGO storage
compartment
13
Close Smart Lock®
Remove paded inserts before installing in forward facing mode
(if tted)

Forward Facing Mode
Remove paded inserts before installing in forward facing mode
Open installation door
Pull
Press
Loosen harness
2
Ensure the tension
indicators shows
green on both sides
12
5
Lift Smart Lock®
handle
67 8
Unbutton seat trim
4
Attach
Attach the top tether
strap
14
Quick Setup with Seatbelt
3
Raise headrest height
13
Close installation door
and restore seat fabric
Recline
Indicator
5
Pull
1
Convert seat to
forward facing mode
11
Close Smart Lock®
Thread seatbelt through belt path
9
click
Fasten the seatbelt
buckle. Re-adjust
clamp as necessary
Remove Slack from Seatbelt
Pull
Push
10
Remove slack
Remove
Slack
15
Remove slack from top
tether
16
Store strap in storage
pocket
17
Place child in the
restraint
19
click
Engage harness buckle
Pull
20
Tighten the harness
21
Double check shoulder
height markers
Harness straps in green zone
18
The shoulder straps
must be in the slots
which are nearest to
the child’s shoulders
but not more than
25mm below the
child’s shoulders.