MaxiCosi Pria Max Instruction Manual

This quick start guide helps you start using your Maxi-Cosi car
seat right away. However, please read the complete instruction
manual and all labeling on the car seat. They include important
warnings and additional safety information.
KEEP INSTRUCTIONS FOR FUTURE USE.
Read all instructions before using this car seat.
WARNING: Failure to follow the warnings on the labels
and in the instruction manual can result in serious injury or
death to your child.
Pria 3-in-1
Convertible Car Seat
Quick Start Installation Guide
4358-7730 3.15.19
10 Check Belt Tightness
Hold at the Forward-Facing
Belt Path.
Push and pull from side to
side.
It should not move more than
1 in. (2.5 cm).
For information on child fit and how to secure
your child in the car seat, please review the full
instruction manual.
Finished!
Check the tightness of the install often.
up to 40 lb (18 kg)up to 65 lb (29 kg)
11

Never install a rear-facing child restraint in
the front seat of a vehicle equipped with an active
frontal airbag.
Recline handle on front of seat
and under pad.
1 2
Rear-Facing Vehicle InstallCar Seat Use Requirements
WARNING
Measure your child’s weight and height (do not guess)
before choosing the car seat’s mode.
This Quick Start Guide is set up to help you get started installing
either the 1st or 2nd mode: Rear-Facing or Forward-Facing.
For Booster Seat mode and other information about choosing car
seat modes, please read the full instruction manual.
continued on next page
There are 2 methods for install. Choose only one:
Do not use both the LATCH: lower anchor belt and
vehicle belt at the same time. When used correctly, the
LATCH: lower anchor belt or vehicle belts are equally safe.
1Place Car Seat Rear-
Facing in Back Seat
Fully Recline Car Seat
2
LATCH:
Lower Anchor Belt
Vehicle Belt OR
FORWARD-FACING MODE
22-65 lb (10.1-29 kg)
and 29-49 in. (73.6-125 cm)
Children must be at least 1 year of age to ride
Forward-Facing.
In this car seat, your child can remain harnessed
Forward-Facing until they outgrow any one of the
following:
Weight Limit: 65 lb (29 kg); OR
Height Limit: 49 in. (125 cm); OR
Forward-Facing child fit requirements. See page 12 of
manual.
REAR-FACING MODE
4-40 lb (1.8-18 kg)
and 19-40 in. (48-101.6 cm)
Children under 1 year of age must ride Rear-Facing.
In this car seat, your child can remain Rear-Facing until
they outgrow any one of the following:
Weight Limit: 40 lb (18 kg); OR
Height Limit: 40 in. (101.6 cm); OR
Rear-Facing child fit requirements. See page 11 of
manual.

3 4
Check Rear-Facing
Level Line
For children who cannot
sit up unassisted, the level
line must be parallel with the
ground.
For children who can sit up
unassisted, you may rotate
the child restraint to be more
upright in Position 2.
Locate Rear-Facing
Belt Path
3
4
Review Your Vehicle Owner’s Manual
Determine what kind of vehicle belt
you have and how to lock a child
restraint in place.
Determine where designated
LATCH: lower anchor seating
positions are located in your
vehicle.
5
OR
1
2
7
Route Belt into Rear-Facing Belt Path
6
Adjuster
Vehicle Belt
Lower Anchor Belt
Connector without the
adjuster closest to it goes
through the Rear-Facing
Belt Path opening as
shown.
Vehicle Belt or Lower
Anchor Belt Goes:
across car seat
under car seat pad
in front of buckle
out other Rear-Facing
Belt Path opening.
Do not twist belt.
Finished Lower
Anchor Belt Routing
OR
Adjuster
continued on next page

5 6
Tighten Belt
9
Secure Car Seat in Vehicle
8
Buckle Vehicle Belt
OR
OR
Attach Lower Anchor
Belt Connectors to
Vehicle’s Anchors in
Seat Bight
Arrows on connectors
face up.
Vehicle Belt Lower Anchor Belt
Finished!
Check the tightness of the install often.
For information on child fit and how to secure
your child in the car seat, please review the
full instruction manual.
10
Recheck Rear-Facing
Level Line
Redo the installation if the
car seat is not reclined
correctly for your child.
11
Check Belt Tightness
Hold at the Rear-Facing
Belt Path.
Push and pull from side to
side.
It should not move more
than 1 in. (2.5 cm).

7 8
continued on next page
1
2
3
Review Your Vehicle Owner’s Manual
Determine what kind of vehicle
belt you have and how to lock a
child restraint in place.
Determine where designated
LATCH: lower anchor seating
positions are located in your
vehicle.
4
OR
Place Car Seat
Forward-Facing in
Back Seat
Put the child restraint into
Position 1.
Vehicle seat back must be
upright.
If your vehicle has a
headrest that interferes
with a flush car seat fit,
check your vehicle owner’s
manual to see if it can be
removed, adjusted, or if there
are other possible seating
locations for you
to install.
Loosely Attach Tether
Hook to Vehicle’s
Tether Anchor
Check vehicle owner’s
manual for specific location.
There are 2 methods for install. Choose only one:
LATCH: Lower Anchor
Belt + Tether
up to 40 lb (18 kg)
Vehicle Belt + Tether
up to 65 lb (29 kg) OR
Do not use both the LATCH: lower anchor belt and
vehicle belt at the same time. When used correctly, the
LATCH: lower anchor belt or vehicle belts are equally safe.
Locate Forward-Facing
Belt Path
Forward-Facing Vehicle Install

9 10
6
7
Tighten Belt
Tighten Tether
Secure Car Seat in Vehicle
8
Buckle Vehicle Belt
OR
Attach Lower Anchor
Belt Connectors to
Vehicle’s Anchors in
Seat Bight
Arrows on connectors
face up.
Route Belt into Forward-Facing Belt Path
5
Adjuster
Vehicle Belt
Lower Anchor Belt
Connector with the
adjuster closest to it goes
through the Forward-
Facing Belt Path
opening as shown.
OR
Finished Lower
Anchor Belt Routing
Adjuster
continued on next page