MaxLite E9A19SMTR User manual

Operating Instructions E9A19SMTR
MaxLite Enclosed Smart A19 Lamp (E9A19SMTR)
© Copyright 2023. MaxLite, Inc. All Rights Reserved.
340 Changebridge Rd, STE 201, Pine Brook, NJ 07058 Tel: [phone] Fax: [phone] Email: [email protected]
Page: 1
REV: 09/08/23
®
Picture is for illustration
purposes only.
Your model may vary.
WARNING – Risk of electric shock. Grounding continuity must be maintained.
AVERTISSEMENT – Risque de la décharge électrique. La mise du courant a la terre doit être
continuellement maintenue.
General Safety Information
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
Quick Start for Enclosed Smart A19 Lamp
1. Download Tuya Smart app from the App Store or Google Play.
2. Connect mobile device to your 2.4GHz Wi-Fi network. Please note this smart plug can only be
connected via a 2.4GHz network.
3. Launch the Tuya Smart app and follow the on-screen instructions to connect the smart plug to your network.
a.) Login to Tuya Smart b.) To begin pairing the
smart plug, hold power
button for 5 sec. Next
click "Add Device".
c.) Once smart lamp
has been found,
click "Add".
d.) Connect app to Wi-Fi.
NOTE: Different mobile operating systems may have some small variations in the setup
process shown in the steps below.

© Copyright 2023. MaxLite, Inc. All Rights Reserved.
340 Changebridge Rd, STE 201, Pine Brook, NJ 07058 Tel: [phone] Fax: [phone] Email: [email protected]
Page: 2
REV: 09/08/23
Quick Start for Enclosed Smart A19 Lamp (Continued)
e.) Wait until you see the
"Added sucessfully"
message and press
"Done".
f.) Smart lamp can now
be controlled via
Tuya Smart app.
g) Customize detailed
controls to fine tune
your experience.
h.) From here you can
change the name or
link to Alexa or
Google Assistant for
voice controls.
(Follow on-screen
instructions to setup.)
Manual Setup for Enclosed Smart A19 Lamp
a.) Login to Tuya Smart. b.) Press “Add Device”
button.
c.) Choose “Light Source
(BLE+Wi-Fi)” from
the menu.
d.) Follow the on-screen
prompts to pair the
device.
Operating Instructions E9A19SMTR
MaxLite Enclosed Smart A19 Lamp (E9A19SMTR)
®

© Copyright 2023. MaxLite, Inc. All Rights Reserved.
340 Changebridge Rd, STE 201, Pine Brook, NJ 07058 Tel: [phone] Fax: [phone] Email: [email protected]
Page: 3
REV: 09/08/23
FCC Statement: This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocat the receiving antenna
- Increase the separation between the equipment and receiver
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Note: The Grantee is not responsible for any changes or modifications not expressly approved by the party
responsible for compliance, such modifications could void the user’s authority to operate equipment.
The device has been evaluated to meet general RF exposure requirement.
To maintain compliance with FCC’s RF exposure guidelines, the distance must be at least 20 cm between the radiator
and your body, and fully supported by the operating and installation configurations of the transmitter and its antenna(s)
IC Caution: This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation,Science and
Economic Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may
cause undesired operation of the device.
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment.
Cet appareil contient des émetteurs / récepteurs exemptés de licence
conformes aux RSS(RSS) d’Innovation, Sciences et Développement économique Canada.
Le fonctionnement est soumis aux deux conditions suivantes:
(1) Cet appareil ne doit pas causer d’interférences.
(2) Cet appareil doit accepter toutes les interférences, y compris celles
susceptibles de provoquer un fonctionnement indésirable de l’appareil.
Tout changement ou modification non expressément approuvé par la partie responsible
de la conformité pourrait annuler l’autorité de l’utilisateur à utiliser l’équipement.
Operating Instructions E9A19SMTR
MaxLite Enclosed Smart A19 Lamp (E9A19SMTR)
®

© Copyright 2023. MaxLite, Inc. All Rights Reserved.
340 Changebridge Rd, STE 201, Pine Brook, NJ 07058 Tel: [phone] Fax: [phone] Email: [email protected]
Page: 4
REV: 09/08/23
MaxLite Inc. warrants its products for a minimum period of ONE (1) years from the earlier of the actual installation date
or 90 days after the original date of purchase from a MaxLite authorized distributor/dealer (the “Warranty Period”), as
follows: If a Product fails to operate during the Warranty Period as a result of defects in materials or workmanship,
MaxLite will, at its option, repair it, replace it with the same or like Product.
Please refer to Maxlite’s website (at http://maxlite.com/resources/warranties) for the complete coverage details as well
as the terms and conditions of our warranty. Please note that it is NOT a requirement to register your warranty in order
to initiate a warranty claim unless a Ten Year warranty has been purchased separately, or when applicable and/or
purchased separately, your warranty contains a replacement labor allowance.
Limitation of Liability
THIS WARRANTY IS EXCLUSIVE, AND IS THE SOLE REMEDY FOR ANY AND ALL CLAIMS, WHETHER IN
CONTRACT, IN TORT OR OTHERWISE ARISING FROM THE FAILURE OF PRODUCT AND IS IN LIEU OF ALL
OTHER WARRANTIES, EXPRESS OR IMPLIED, INCLUDING ALL WARRANTIES OF MERCHANTABILITY OR
FITNESS FOR A PARTICULAR PURPOSE, WHICH WARRANTIES ARE HEREBY EXPRESSLY DISCLAIMED TO
THE EXTENT PERMITTED BY LAW AND, IN ANY EVENT, SHALL BE LIMITED TO THE WARRANTY PERIOD
SPECIFIED ABOVE. THE LIABILITY OF MAXLITE SHALL BE LIMITED TO THE TERMS OF THE EXPRESS
WARRANTY SET FORTH HEREIN. IN NO EVENT WILL MAXLITE BE LIABLE FOR ANY SPECIAL, INCIDENTAL
OR CONSEQUENTIAL DAMAGES INCLUDING, WITHOUT LIMITATION, DAMAGES RESULTING FROM LOSS OF
USE, PROFITS, BUSINESS OR GOODWILL, LABOR COSTS, REMOVAL OR INSTALLATION COSTS, WHETHER
OR NOT MAXLITE HAS BEEN ADVISED OF THE POSSIBILITY THEREOF. UNDER NO CIRCUMSTANCES SHALL
MAXLITE’S ENTIRE LIABILITY FOR A DEFECTIVE PRODUCT EXCEED THE PURCHASE PRICE OF THAT
PRODUCT (EXCLUDING LABOR WARRANTY COVERAGE WHERE SPECIFCALLY OFFERED BY MAXLITE).
WARRANTY SERVICES PROVIDED UNDER THESE TERMS AND CONDITIONS DONOT ENSURE THE
UNINTERRUPTED OPERATION OF PRODUCTS; MAXLITE SHALL NOT BE LIABLE FOR DAMAGES CAUSED
BY ANY DELAYS INVOLVING WARRANTY SERVICE.
This Warranty gives you specific legal rights and you may also have other rights that may vary from state to state.
Because some states or jurisdictions do not allow the exclusion or limitation of liability for consequential or incidental
damages, such limitation may not apply to you.
Warranty Information
Operating Instructions E9A19SMTR
MaxLite Enclosed Smart A19 Lamp (E9A19SMTR)
®